Spindle Questions
- 1994 Nissan Hardbody Electrical Problem with 101 miles
- Just bought a 1994 Nissan Hardbody truck. Just noticed that the odometer seems to work intermittently. It can start off not working, but ...
- Asked by (pending member) about 4 months ago - 1 Answer
- 2005 Mitsubishi Outlander Engine Problem with 170000 miles
- How to take the alternator off? releasing of the tensioner belt?
- Asked by (pending member) about 4 months ago - 2 Answers
- 2003 Vauxhall Zafira Repair Problem with 39000 miles
- I am replacing a faulty rear wiper motor on a zafira but I'm unable to detach the wiper arm from the motor spindle. I have unscrewed the nut...
- Asked by Pongoli about 4 months ago - 0 Answers
- 1999 Pontiac Grand Am Suspension Problem with 280783 miles
- I was told i needed to replace a right rear control arm and spindle rod do these have other names and where they located
- Asked by (pending member) about 4 months ago - 1 Answer
- 1994 Ford Thunderbird Suspension Problem with 84357 miles
- Wen i replaced my front breaks i noticed while it was jacked up only the right front wheele had about an inch of play while the left side ...
- Asked by (pending member) about 4 months ago - 1 Answer
- 2007 Acura TL with 68000 miles
- The front left CV boot is cracked. I am having the axle replaced but the shop is recommending an alignment. Is the alignment recommended?
- Asked by j.czar1@verizon.net about 5 months ago - 1 Answer
- 1991 Mercury Capri Repair Problem with 157000 miles
- Just need to know what size the spindle nut is ? so i can remove it , manual trans.
- Asked by (pending member) about 5 months ago - 0 Answers
- 2001 Chrysler 300 Suspension Problem with 120343 miles
- Car is on its 3rd set of Mopar struts in a year. repair man says it is faulty shocks. the shock plate keeps separating from the shock on ...
- Asked by julia nelis about 5 months ago - 0 Answers
- 1984 Nissan Hardbody Brakes Problem with 145 miles
- How do you replace the front rotors on a 1984 720 4x4 with a 5spd manual transmission and a 2.4L engine?
- Asked by slacker128 about 5 months ago - 1 Answer
- 2004 Suzuki Liana Repair Problem with 70000 miles
- After taking all the relevent parts off the front wheel, brake caliper, large nut, track rod , ect does the bearing housing just knock off ...
- Asked by (pending member) about 5 months ago - 1 Answer
- 1995 Jaguar XJS Brakes Problem with 56000 miles
- How do i remove front caliper and rotors on 1995 jaguar xjs
- Asked by (pending member) about 5 months ago - 1 Answer
- 2004 Dodge Stratus Drivetrain Problem with 121722 miles
- My axle on front driver side moves from front to back really easy. Now the boots aren't torn and shaft looks good so I was wondering if I ...
- Asked by aldrodout024 about 5 months ago - 1 Answer
- 1999 Chrysler 300 with 218000 miles
- What are tie rods
- Asked by (pending member) about 5 months ago - 1 Answer
- 2004 Ford Ranger Noise Problem
- How to tell if spindle is bad
- Asked by (pending member) about 5 months ago - 1 Answer
- 2005 Pontiac Grand Prix Steering Problem with 95000 miles
- When replaceing the rack and pinon unit is this really a project for the real mec;? I do have a nice shop to work out of, and will have most...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1997 Ford Expedition Brakes Problem
- I have replaced the master cylinder and bench bled it also replaced the spindle kit, tie rod, bearings, ball joints on driver side along ...
- Asked by (pending member) about 6 months ago - 0 Answers
- 2000 Suzuki Esteem Drivetrain Problem with 147895 miles
- How do u remove the front hub bearings on a 2000 Suzuki esteem 1.8 liter with automatic transmission
- Asked by (pending member) about 6 months ago - 1 Answer
- 1998 Honda CRV Drivetrain Problem with 10000 miles
- What is the easiest way to change the Rear Wheel Bearing?
- Asked by (pending member) about 6 months ago - 1 Answer
- 1995 Mitsubishi Eclipse Repair Problem with 183000 miles
- HELLLPPPPP!! I have a 95 eclipse gsx AWD and my passenger rear spindle is snapped were it connects to the lower control arm, anyway i have...
- Asked by 95eclipsegsx about 6 months ago - 1 Answer
- 2000 Pontiac Grand Prix Engine Problem
- Why does my car vibrate really bad when i accelerate? it feels like something lose.
- Asked by (pending member) about 6 months ago - 1 Answer
- 1998 GMC Savana Brakes Problem with 90000 miles
- This is a van converted to transport wheelchairs, it now has approx 6 or 7 extra hundred lbs and with a power w/c inside, you can add an ...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1999 Ford Ranger Suspension Problem with 16000 miles
- I recently replaced the front upper ball joints and control arms. I am paranoid that the joint will seperate from the spindle. I tighened ...
- Asked by derek_fox1 about 6 months ago - 2 Answers
- 1993 Lincoln Mark VIII Repair Problem with 111000 miles
- How hard is it to replace the rack and pinion n how much will it cost for parts
- Asked by (pending member) about 6 months ago - 1 Answer
- 2008 Peugeot 308 Interior Problem with 46500 miles
- My car the seat belt on the front passenger side has Stuck cannot pull out.
- Asked by shyamilyash about 6 months ago - 1 Answer
- 1995 Chevrolet S-10 Suspension Problem with 170000 miles
- Truck had front end damage few years back we found out repair shop put used lower control arm and shock which was prior 1981. we reinstall ...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1998 Nissan 200SX Noise Problem with 285 miles
- There is a grinding or rubbing sound coming from the front passengers side. I have replaced both hub bearing, spindle and hub assembly (...
- Asked by michelleleahenson about 6 months ago - 1 Answer
- 1998 Buick Century Steering Problem with 110000 miles
- Hard turning right only, I have replaced the rack power steering pump and complete struts with springs.. I am stuck???? Dennis
- Asked by (pending member) about 6 months ago - 1 Answer
- 2002 Toyota Vitz with 97888 miles
- Hi im new here. im andy from malta :) . since i need help ....i serviced my vitz 2001 1.0 auto. so i decided to clean the throtle . i pulled...
- Asked by (pending member) about 6 months ago - 1 Answer
- 2010 GMC C1500 Steering Problem with 38000 miles
- MINOR ACCIDENT COLLIDED WITH A SMALL LEXUS SUV MY FRONT DRIVERS SIDE FENDER TO THEIR PASS SIDE FENDER / WHEEL . SEEMED LIKE WE COLLIDED AT A...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1994 Ford Bronco Suspension Problem with 138000 miles
- I have a 94 bronco and the tire sits slanted, if i remove the tire, the brakes and rotor all seem loose and move up and down, could you tell...
- Asked by jameskirkpatrick about 6 months ago - 14 Answers
- 2003 Hyundai Sonata Repair Problem with 53000 miles
- When driving the front drivers wiper arm stopped working in the upright position and sat along the drivers front side windscreen. we stopped...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1985 Chevrolet El Camino Suspension Problem with 100000 miles
- How to remove and replace upper and lower controlarm bushings
- Asked by (pending member) about 7 months ago - 1 Answer
- 1995 Buick Riviera Repair Problem
- How do i get the driver side axle out to put a new one in.....The problem is it has a little pop in the take off power and i have to replace...
- Asked by (pending member) about 7 months ago - 1 Answer
- 2008 Volvo XC70 Drivetrain Problem with 65000 miles
- I have a bad bearing in the right front axle. The axle assembly is over $600 but I can replace the bearing for $145. Problem is when I went ...
- Asked by (pending member) about 7 months ago - 3 Answers
- 1998 Dodge Durango Repair Problem
- When i take tire off the hub is shaking back and forth and when i drive its like there is a scraping noise i'm not sure why
- Asked by drewrounds about 7 months ago - 3 Answers
- 1992 Ford Thunderbird Drivetrain Problem with 69875 miles
- The hub nut which I just got from the dealer consists of three nuts enclosed in a wrap around locking device. do I need to separate the ...
- Asked by cm1dav about 7 months ago - 6 Answers
- 1994 Ford Escort Steering Problem with 129000 miles
- Replaced front right strut car pulls bad to right how to adjust
- Asked by sunnysue999 about 8 months ago - 1 Answer
- 1996 Buick Regal Suspension Problem with 175600 miles
- NTB told me the strut retaining nut is cross-threaded and the spindle needed to be replaced! I installed the struts and hand started the nut...
- Asked by Firemnted about 8 months ago - 4 Answers
- 2003 Chevrolet Cavalier problem with 90000 miles
- CAN YOU TELL ME THE SIZE SOCKET NEEDED TO REMOVE THE NUT ON THE FRONT AXLE OF A 2003 CHEVY CAVALIER?
- Asked by jimlewisn about 8 months ago - 1 Answer
- 1991 Acura Integra Drivetrain Problem with 270 miles
- I need to replace the transmission seal on my 91 Integra, and I have been told I need a seal puller (tool) to do this. My question is, what ...
- Asked by mikemiller1 about 8 months ago - 3 Answers
- 2004 BMW 530i Steering Problem with 50 miles
- I lightly hit a pole when backing up. There was a superficial 6" scrape to the rear left quarterpanel slightly behind the left rear wheel ...
- Asked by warren3 about 8 months ago - 4 Answers
- 2004 Acura RSX Brakes Problem with 1300 miles
- I am trying to change a axle stud on a 2004 Acura rsx type s. I am trying to get the axle nut off but the whole hub is turning with it. Help...
- Asked by chriskirloff about 9 months ago - 5 Answers
- 1997 Dodge Dakota Drivetrain Problem with 325000 miles
- Need to change out front wheel bearing assemblies
- Asked by BoatP2Lee about 9 months ago - 10 Answers
- 1998 Oldsmobile Aurora Steering Problem with 189000 miles
- 98 oldsmobile Aurora axel stuck in spindle and want come out done tried pulling and tapping and nothing its a 4.0 v8 engine axel is new
- Asked by tracyandamandabarham about 9 months ago - 4 Answers
- 1994 Dodge Dakota Brakes Problem with 156000 miles
- I see a lot of guys upgrading their front brakes by swapping out the steering knuckles and all associated parts, to ones from a 2003 Dakota...
- Asked by irvulture about 9 months ago - 1 Answer
- 2000 Lincoln Town Car Brakes Problem with 160000 miles
- Deiving home the other night, i was getting off the Highway when my car rumbled and would suddenly stop. I am missing a bolt that holds ...
- Asked by msmccorkle about 9 months ago - 7 Answers
- 1997 Honda Accord Repair Problem
- How to remove the front spindle nut (hub nut) to replace rotors? Do I need a special tool? If so can I rent it?
- Asked by TonyNeal about 10 months ago - 1 Answer
- 1996 Chrysler Town and Country Brakes Problem with 164000 miles
- The caliper "hangs up" or the caliper piston sticks open. We've changed the caliper twice with a well known rebuilt brand, and we've ...
- Asked by justamom003 about 11 months ago - 5 Answers
- 1995 Honda Accord Drivetrain Problem with 120000 miles
- I am unable to re-install my knuckle because the upper and lower ball joints won’t align, as if the outer CV joint has been displaced ...
- Asked by tmounib about 11 months ago - 2 Answers
- 2003 Volvo S80 Steering Problem with 215000 miles
- Hi I have a 2003 Volvo S80 2.4l 5cylinder engine FWD, the problem is than when Im turning left the car vibrates/whobbles but if i eft go of ...
- Asked by project_s80 about 1 year ago - 3 Answers
Related Topics
Got a Car Question?
Automotive repair can be puzzling without the right information. Fortunately, 2Carpros was created to help people with everyday repair problems in mind. New systems are being introduced yearly, instruction is needed to complete a service or repair. We offer access to a panel of ASE and manufacturer specific certified mechanics that are dedicated to guide novices and experts alike in any repair. After a detailed question enters our system it's filtered to a specializing mechanic. Once the problem has been indentified our technician will respond with diagrams, instruction and any additional information required. 2Carpros is a completely FREE service. Our technicians are compensated through donations and advertising revenue.
Ask a QuestionNot Sure Where to Start?
Most car repair is basic and straight forward. Unfortunately auto related problems such as "electrical" and "engine performance" issues can be complicated. These styles of problems can create confusion which leads to unnecessary repairs. These mistakes not only consume resources they waste time as well. Having the correct instruction can pinpoint the malfunction while generating the proper repair procedure. Our first things to check section includes step by step "do it yourself" troubleshooting guides that offer video with illustrations showing hands on interaction while providing tips of the trade for a successful car repair.
First Things to Check