Axle Puller Questions

1996 Acura TL Engine Problem

I have the inline slant 5 cylinder 2.5 l motor for my TL. Thr motor blew and i will be replacing it with another used 5 cylinder motor. My...

Asked by dodge504ram about 3 days ago - 1 Answer

1982 Ford Cortina Repair Problem with 200000 miles

How to change rear left wheel bearing.I have stripped drum/brakes/ext.I have removed dif cap and caps for crown and pinion.How do i remove ...

Asked by (pending member) about 3 months ago - 1 Answer

1999 Subaru Legacy Brakes Problem with 79000 miles

How to replace a front wheel bearing?

Asked by (pending member) about 3 months ago - 1 Answer

1991 Lexus LS 400 Repair Problem

How do I replace Back Hub on drivers side

Asked by (pending member) about 3 months ago - 1 Answer

2008 Jeep Liberty Steering Problem with 30000 miles

Replace rack and pinion

Asked by rondel about 4 months ago - 1 Answer

1991 Subaru Brumby with 29300 miles

How do i change the front right hand wheel bearing?

Asked by (pending member) about 5 months ago - 1 Answer

2003 Dodge Dakota Drivetrain Problem with 150000 miles

Im stuck in the middle of replacing a BEARING on the INSIDE of the front DIFFERENTIAL on my 2003 4.7L V8 Dakota, i have the CV shaft off, ...

Asked by (pending member) about 5 months ago - 1 Answer

2001 Jeep Grand Cherokee with 13000 miles

How To Replace Real Axel Seal?

Asked by (pending member) about 6 months ago - 1 Answer

1998 Mazda MPV Drivetrain Problem with 130000 miles

This is a 4x4 mpv all sport van. Left side seal on rear differential is leaking onto Parking brake shoes. How do I remove axle to replace ...

Asked by (pending member) about 6 months ago - 1 Answer

1990 Nissan Stanza Suspension Problem with 150000 miles

Ok my first question was after replacing front bearings,and axle my wheel wouldnt tighten up.i checked the bearings and they were just ...

Asked by donnawoodlee about 6 months ago - 19 Answers

1999 Infiniti Infinity QX4 with 16000 miles

How I can replace the left front drive shaft

Asked by (pending member) about 6 months ago - 1 Answer

2007 Subaru Outback Drivetrain Problem with 120000 miles

How to remove front half axle from differential & hub

Asked by DOH123 about 7 months ago - 2 Answers

1996 Oldsmobile Bravada Suspension Problem with 180000 miles

What tools will I need to replace the wheel bearings on a 1996 Olds Bravada (front)?

Asked by Doug the Wireguy about 7 months ago - 1 Answer

1991 Acura Integra Drivetrain Problem with 270 miles

I need to replace the transmission seal on my 91 Integra, and I have been told I need a seal puller (tool) to do this. My question is, what ...

Asked by mikemiller1 about 8 months ago - 3 Answers

1998 Saturn SC2 problem with 230 miles

I got to it but it is hard to get off is there anyway to get it off or is it just a pain in the A**

Asked by bbarbo9 about 11 months ago - 3 Answers

2001 Ford Ranger Steering Problem with 74000 miles

The seal where the cv axel goies into the diff I need to know a step by step to get the cv out I have replaced the wheel bearing on that ...

Asked by derek97116 about 11 months ago - 1 Answer

2008 Audi TT Suspension Problem with 70000 miles

I was wondring how i remove the front struts on this car and replace them, and the instalation procedure if you can provide me some ...

Asked by rob.kela about 1 year ago - 4 Answers

2003 Chevrolet Blazer Suspension Problem with 160 miles

2003 Chevy Blazer LS 4WD V6; installing replacement upper balljoints; 1/4"flange w/4bolt holes fits top of control arm instead of punched ...

Asked by crashwell about 1 year ago - 3 Answers

1992 Mazda b2600 Repair Problem

The cv axel wont come off. Having a hard time.

Asked by Tgunsak about 1 year ago - 4 Answers

2001 Peugeot 307 Drivetrain Problem with 105000 miles

How do i pull my driveshaft out

Asked by reid_1978 about 1 year ago - 1 Answer

1994 Mercury Capri Drivetrain Problem with 100000 miles

I took The spendle or stearing knuckle off the car. I need to change the wheel bearing.I can't seperate the hub from the rotor.the 4 bolts ...

Asked by heavyarms about 1 year ago - 3 Answers

2001 Volkswagen GTI Suspension Problem with 90000 miles

I have mechanic knowledge just never had a vw before.Just looking for a little assistance.Need to change rear hub because the wheel is ready...

Asked by airic74 about 1 year ago - 0 Answers

1998 Ford Windstar problem with 300000 miles

I'm having trouble changing the bearings. I have a bearing puller but the bearings are rusty I can't pull them out. Is there another way I ...

Asked by debid12 about 1 year ago - 0 Answers

1998 Ford Windstar problem with 300000 miles

I need to to know to replace ball bearing on my right front. I need to know how to remove the CV joint to replace the bearings in the front...

Asked by debid12 about 1 year ago - 1 Answer

1999 Ford F-150 Drivetrain Problem with 16900 miles

It was working 2high to4high got under it with test light because it would not come out of four wheel now stuck in four wheel high

Asked by dalekern about 1 year ago - 0 Answers

1997 Chevrolet Cavalier Drivetrain Problem with 286000 miles

Hi. I'm replacing the left side axle seal (transmission output shaft seal) on my 97 cavalier. Seal is actually 2 pc; an inner sleeve which ...

Asked by r2thman about 1 year ago - 1 Answer

2007 Lincoln MKZ Repair Problem with 130000 miles

Not first brake job but first on mkz. caliper off but unable to get rotor to move. Used penetration oil, tapped with hammer, no movement. ...

Asked by oleguy about 1 year ago - 0 Answers

1995 Chevrolet Truck Drivetrain Problem with 220000 miles

Front driver side axle seal is leaking, how do i pull drive axle from differencial

Asked by spider95 about 1 year ago - 2 Answers

1985 Jaguar XJ6 problem with 12600 miles

I keep lining up the shaft with the hub, but it just won't go in.

Asked by chosa about 1 year ago - 1 Answer

1999 Ford Explorer Drivetrain Problem

Have pulled brakes, how do you remove axle to replace the bearing?

Asked by ksharness about 1 year ago - 2 Answers

2000 SAAB 9-5 Repair Problem with 180000 miles

What is the name of the part that I need to take off? Are any special tools needed? Would I be able to press the old one out and press the ...

Asked by lunch about 1 year ago - 0 Answers

2005 Chevrolet Tahoe Brakes Problem with 84000 miles

I removed the wheel the brake caliper and the caliper bracket and end axle nut on the left front wheel of my suv. how do i get the brake ...

Asked by melnric about 1 year ago - 0 Answers

1999 Mercury Marquis Brakes Problem with 120000 miles

Right rear rotor moves slightly but wont come off is it a emergancy brake stuck or do i use brute force and hit it hard with a heavy hammer...

Asked by vince danagher about 1 year ago - 1 Answer

1996 Daewoo Cielo Body Problem with 250000 miles

Need to install new ignition barrel.cannot turn ignition with the other half key

Asked by urick007 about 1 year ago - 0 Answers

1994 Mazda b4000 Drivetrain Problem with 159000 miles

I need to know if i will have to remove the ball joints to change the cv axles

Asked by rwp6495 about 1 year ago - 0 Answers

1998 Dodge Ram problem with 180000 miles

How do I change the lower seal on the gearbox on a 98 Dodge ram 1500 4x4 5.9

Asked by celticpride53 about 1 year ago - 0 Answers

1997 Hyundai Lantra problem with 164 miles

Do I need to remove the front wheel hubs to change the brake discs on my 1997 Lantra Siena?

Asked by wheelsup about 1 year ago - 0 Answers

2003 Honda CRV problem with 270000 miles

How do I remove rear spline from hub on my 2003 crv

Asked by SS04 about 1 year ago - 0 Answers

2007 Subaru Outback problem

How do i replace the front drivers side drive axle of my 07 subaru outback automatic 2.5i?

Asked by saywers2006 about 1 year ago - 0 Answers

2001 Subaru Outback problem

Enter your question...front wheel bearing replacement on a 2001 outback

Asked by wellmaker about 1 year ago - 2 Answers

2004 Kia Sorento problem with 79007 miles

I have a 2005 Kia Sorento 4x4 and need to change the disc pads and have the rotors machined. I have removed the caliper assembly and the ...

Asked by mslape about 1 year ago - 1 Answer

1996 GMC Suburban problem with 300000 miles

How do I replace the rear bearings in a 1996 gmc suburban

Asked by ylynd about 1 year ago - 0 Answers

1985 Subaru Wagon problem with 180000 miles

I have a 1985 subaru wagon gl and the cv joint is out, I was wonder after I take off the brake and then the cover plate, how do I get the ...

Asked by TTR24 about 2 years ago - 0 Answers

1998 Chevrolet Malibu problem with 70000 miles

How do i replace front wheel bearings on a 1998 malibu

Asked by flybynyte about 2 years ago - 0 Answers

1997 Acura RL problem with 265000 miles

With the difficulty of replacing a oil pan seal on a 1997 Accura RL should I even try this at home? I was told by three different shops the...

Asked by hoopitupking about 2 years ago - 0 Answers

2001 Honda Civic problem with 150000 miles

How to replace left-side(drivers side) cv axle on a 2001 honda civic ex

Asked by dammitbob about 2 years ago - 0 Answers

1995 Honda Accord problem with 134000 miles

1995 honda accord cv boot

Asked by kana684 about 2 years ago - 0 Answers

1983 Mercedes Benz 380sl problem

Need instructions to replace rear brake pads on mercedes 1983 380sl

Asked by Daniel Andrew about 2 years ago - 0 Answers

2001 Ford F-150 problem with 100000 miles

Replacing front wheel berings 2001 f150 4x4

Asked by blakjak about 2 years ago - 0 Answers

2001 Hyundai Elantra problem

How do i remove and replace broken wheel bearings on a 2001 elantra? i just replaced my passenger side axle and removed the hub, doing so, ...

Asked by romad about 2 years ago - 0 Answers

Related Topics