Cam Follower Questions

1999 Nissan Primera Engine Problem with 120546 miles

Intermittently the engine loses power or hesitates when accelerating. When trying to accelerate hesitation can last anywhere betwen 1 second...

Asked by lukemcf about 1 day ago - 1 Answer

2011 Ford Fiesta Engine Problem with 24790 miles

Hi could you tell me how many cam followers would be in my car which is a 1.2 zetec and how easy it would be to replace, the engine warning...

Asked by jamiefletcher1968 about 10 days ago - 1 Answer

2006 Honda City Drivetrain Problem with 80000 miles

01-01 O2S(HO2S) (S1) Voltage low. 15-08 IGNITION OUTPUT SIGNAL FAILURE. Car is knocking as accelerator is pressed on 3rd and onward ...

Asked by fahdaslam about 16 days ago - 9 Answers

2000 Vauxhall Other Engine Problem with 13000 miles

My Vauxhall brava has an Isuzu 2.5 diesel engine .the time belt has broken and I need to retime the engine. I would like to know what to ...

Asked by dafydd about 19 days ago - 1 Answer

2007 Chrysler Pacifica Drivetrain Problem with 160000 miles

4.0 Liter engine (Touring AWD model). I am working on removing the head. I can't find a tool to hold the sprocket from rotating. It seems ...

Asked by wgwartney about 20 days ago - 3 Answers

2002 Suzuki Aerio Noise Problem with 10400 miles

I just bought this car to do a engine swap with a 2008 SX4 donor car I have. i found the head to be different, with the cam position sensors...

Asked by Kdzee about 1 month ago - 7 Answers

2002 Ford Focus Noise Problem with 78000 miles

I have a 2002 ford focus ZTS ZETEC engine with 78,000 miles on it. Recently I have this weird popping/clicking noise that has developed. It ...

Asked by skiboy78 about 1 month ago - 1 Answer

1998 Ford Ranger Engine Problem with 235000 miles

Truck starts but isles extremely rough. Timing belt hs s not been checked for tdc. Hsve been told that #3 cylinder is bsd but I have ...

Asked by magwolf about 1 month ago - 1 Answer

2006 Chevrolet Impala Electrical Problem with 125000 miles

Found loose connection mass air flow that code now gone, however i have a p0010 code appearing ,Camshaft Position Actuator Circuit (Bank 1) ...

Asked by cabby022 about 1 month ago - 4 Answers

1984 Jeep CJ7 Electrical Problem with 50000 miles

Greetings from Alaska, Having a bear of a problem with my 1984 CJ7 Laredo. This is a MUCH modified CJ. 1979 258 block, .030 over, 4....

Asked by akmilsurp about 1 month ago - 30 Answers

2000 Ford F-150 Engine Problem with 200000 miles

Motor coughs, spits, and sputters when lightly pressing accelarator but will run fine if you punch it and it will idle fine also. I have ...

Asked by tgravy about 1 month ago - 5 Answers

2003 Mitsubishi Montero Engine Problem with 176000 miles

My car started leaking oil all over the engine yesterday. I took it to a reputable mechanic and they are telling me they need replace the ...

Asked by jphorton about 2 months ago - 1 Answer

1999 Toyota Rav4 Drivetrain Problem

I just installed a new cam shaft sensor before replacing a worn timing belt and i am still getting a P0340 code and I was wondering does A ...

Asked by seabeematt about 2 months ago - 3 Answers

1996 Volkswagen Golf Engine Problem with 147 miles

Head bolts and cam shaft nuts torque settings

Asked by scott2020 about 2 months ago - 2 Answers

2001 Dodge Neon Engine Problem with 120000 miles

I have a 2001 Dodge Neon SE 2.0 I recently bought. It makes a loud ticking or knocking sound until about 1500 rpm, then it goes away. It ...

Asked by (pending member) about 2 months ago - 3 Answers

1994 Mitsubishi 3000GT Engine Problem with 150000 miles

How to install the timing belt?

Asked by miguel34 about 2 months ago - 1 Answer

1999 Dodge Ram Engine Problem with 170000 miles

My 99 Dodge ram 5.9 has a really bad idle i have done the following plugs wires rotor and cap coil IAC tps injectors and fuel pump no check ...

Asked by hudson89 about 2 months ago - 7 Answers

2002 Nissan Sentra with 180000 miles

2002 Nissan Sentra GXE 1.8 liter motor. P0335 code. Runs a little rough at an idle when in gear. No check engine light. Hesitates when I ...

Asked by JimKes about 2 months ago - 16 Answers

1997 Oldsmobile Achieva Engine Problem

Why will my car not start after I have replaced almost all the sensors. which include the following: crank sensor, cam sensor, IAC sensor, ...

Asked by spencerbaker about 2 months ago - 1 Answer

2001 Chevrolet Silverado Electrical Problem with 75000 miles

Have a 2500hd with an 8.1. Giving code p0342 low input on the camshaft sensor.I have already replaced the sensor and connector and put a new...

Asked by kylemeyer about 2 months ago - 5 Answers

2000 Toyota Tacoma Engine Problem with 210000 miles

Where is the oil pump located

Asked by (pending member) about 3 months ago - 1 Answer

1988 Oldsmobile Delta 88 Engine Problem with 139000 miles

I have changed the idel control sensor,clean the throttle body,replaced the camshaft sensor, new plugs and wires,02 sensor, and main ...

Asked by tonyd235 about 3 months ago - 3 Answers

1993 Plymouth Laser Engine Problem with 160 miles

I need to time the distributor to the cam shaft. how do i get the distributor at number 1 when the cam shaft is at top dead center on ...

Asked by philbuckendorf about 3 months ago - 4 Answers

1994 Mitsubishi Mighty Max Engine Problem with 25000 miles

My engine is tapping real bad from under the head cover like the rocker arms are loose. It has plenty of oil preasure so I know it is ...

Asked by ghawk122 about 3 months ago - 4 Answers

1998 GMC Sierra Engine Problem with 135000 miles

How do i eliminate the p1345 code? I have set the timing by setting the #1 cylinder to tdc and set the distributor to #1 cylinder several ...

Asked by henryguilleniii about 3 months ago - 1 Answer

2004 Hyundai Sonata Engine Problem with 44000 miles

Had all the belts, water pump, crank seal, cam seal, idler bearings and tensioner replaced , now car vibrates terribly. Could the mechanic ...

Asked by benrussell about 3 months ago - 4 Answers

1998 Toyota 4Runner Drivetrain Problem with 275000 miles

Just changed timing belt and cam sensor cleared computer codes po340 keeps returning and car has no power could ecm be the problem

Asked by dbl054 about 4 months ago - 1 Answer

2005 Dodge Neon Engine Problem with 125000 miles

My neon chk engine light came on while drivg and my car died..now when I try to start it, it sounds like my starter spins without it ...

Asked by mattcannon about 4 months ago - 5 Answers

2006 Chrysler Pacifica Engine Problem with 93000 miles

So, my check engine light is on. my cruise control only works if i'm going 25mph or less and when it turns off I can't get it back on until...

Asked by bernsm about 4 months ago - 5 Answers

2001 Ford Ranger Engine Problem with 78000 miles

I have a 2001 ranger 4.0 v6 auto with a slight rough idle feels like it has a big cam when sitting inside it i did tune up new plugs and ...

Asked by (pending member) about 4 months ago - 1 Answer

1993 Volvo 940 Engine Problem with 250000 miles

I live in France and have a Volvo Wentworth estate 1993 model that has served me very well for many years but unfortunately developed a ...

Asked by (pending member) about 4 months ago - 3 Answers

1998 GMC Sierra with 186000 miles

Why is illuminated on my dash just replaced cam pos sensor/fuel pump/giving code p1345 crank pos senser/cam pos senser correlation still ...

Asked by (pending member) about 5 months ago - 1 Answer

2004 Chevrolet Colorado with 70000 miles

Check engine troubleshooting diagnostic # on my 2004 Colorado is giving a P0014 / An

Asked by (pending member) about 5 months ago - 1 Answer

2002 Saturn SL2 Engine Problem with 160000 miles

How much work is it to replace a head gasket on the above mentioned car for an average mechanically inclined person? and what all will I ...

Asked by (pending member) about 5 months ago - 1 Answer

2006 Audi A3 Electrical Problem with 70000 miles

I have sent my audi a3 2006 with 150000km on the clock in for a diagnostic. The following codes were returned: 16825 - evap emission ...

Asked by (pending member) about 5 months ago - 0 Answers

1990 Mercury Sable with 100000 miles

I replaced head gaskets on a 1990 Mercury Sable 3.8L V6. The repair manual states the following: "For each valve, rotate the crankshaft ...

Asked by jkarlp about 5 months ago - 2 Answers

1998 Toyota Corolla Engine Problem with 250000 miles

My car is TOYOTA Corolla 2.0 Diesel 1998 (model CE110) I had found oil in the intake manifold and I'm trying to identify and fix the ...

Asked by onlyblue about 6 months ago - 0 Answers

1995 Lexus GS 300 Suspension Problem with 30000 miles

Removing passager side lower control arm

Asked by (pending member) about 6 months ago - 1 Answer

1997 Ford F-350 with 250000 miles

How do you remove mechanical fuel pump from a 7.3 L turbo diesel engine?

Asked by (pending member) about 6 months ago - 1 Answer

2004 Hyundai Elantra Engine Problem with 84000 miles

I have 2004 hyundai elantra 4 cly at 84k not getting fire to plugs.i have replace the following parts that can out of car the same year that...

Asked by (pending member) about 6 months ago - 1 Answer

2003 Chevrolet Trailblazer with 149000 miles

Service engine light is on showing codes p0128 and p0014 what should i expect repairs to cost? Thanks Jack

Asked by (pending member) about 6 months ago - 1 Answer

1996 Chrysler Town and Country Electrical Problem with 24500 miles

Its a 3.8,is there a coil sensor,if so where is it located,code po340

Asked by (pending member) about 6 months ago - 7 Answers

2005 Subaru Impreza Electrical Problem with 103000 miles

You might have to get creative and think outside the box on this one. I’ve been to probably 2 dozen mechanics and they’ve been very ...

Asked by (pending member) about 6 months ago - 0 Answers

2002 Ford Focus Engine Problem with 11300 miles

There been a tapping noise from topend off my foxus 1.4 petrol engine i know its the tappets. but today on way to work i had huge power loss...

Asked by derrickrowlandsrowlands about 6 months ago - 1 Answer

1995 Mazda b3000 Electrical Problem with 175000 miles

My check engine lights is on code says cam position sensor this is a 1995 mazda B3000 3.0 4x4 truck question the sensor is at the back of ...

Asked by (pending member) about 6 months ago - 1 Answer

1997 Ford Mustang Engine Problem with 150 miles

I am puting parformance comp cams in my mustang but they are used so i was wondering how to go about geting rid of wear patternson the cam ...

Asked by (pending member) about 6 months ago - 1 Answer

1991 Chevrolet Lumina Engine Problem with 291868 miles

I have a 1991 Chevrolet Lumina with a 3.1L V6. The timing chain broke and valves were bent. Instill of having to have the heads repaired, I ...

Asked by Pilotbill about 7 months ago - 1 Answer

1996 Ford Mustang Engine Problem with 14000 miles

I am losing oil (crankcase,5/30 w.) at the rate of 1 qt. per week. It is not using oil but is spraying underneath the car but only on the ...

Asked by larry smooth 3439 about 7 months ago - 1 Answer

1996 Ford Mondeo Drivetrain Problem with 91000 miles

I replaced my starter and the following day it started and died. Now sounds like no compression. Cam belt tight ( 2500 miles ) any ideas ?

Asked by (pending member) about 7 months ago - 0 Answers

2000 Chrysler Concorde Engine Problem with 214000 miles

I'm changing a water pump on 2.7 engine. i lined up timing mark on oil pump housing to take chain off, but could not get to cam shaft ...

Asked by (pending member) about 7 months ago - 1 Answer

Related Topics