Cam Bearings Questions

2002 Suzuki Aerio Noise Problem with 10400 miles

I just bought this car to do a engine swap with a 2008 SX4 donor car I have. i found the head to be different, with the cam position sensors...

Asked by Kdzee about 4 days ago - 7 Answers

2002 Chevrolet Cavalier Repair Problem with 130000 miles

The wheel fell off my car. I know nothing about them. The history of this problem is I've had to replace the barrings on this wheel twice. I...

Asked by guy30000 about 15 days ago - 1 Answer

1984 Jeep CJ7 Electrical Problem with 50000 miles

Greetings from Alaska, Having a bear of a problem with my 1984 CJ7 Laredo. This is a MUCH modified CJ. 1979 258 block, .030 over, 4....

Asked by akmilsurp about 19 days ago - 30 Answers

1997 Honda Civic Repair Problem with 113000 miles

The bracket that thr distributor bolts onto at the cam-end of the valve cover has snapped off pulling the didtributor away from the cam and ...

Asked by deeschmee about 23 days ago - 4 Answers

1984 Chevrolet Chevette Noise Problem with 20000 miles

If you rev up motor it makes noise like a bad bearing and oil pressure drops to 0#.when motor goes back to idle speed oil pressure goes back...

Asked by goldwing 06 about 25 days ago - 1 Answer

Camshaft issues Engine Problem

The head threw the camshaft seal and when you look around the cam into the head there is a metal round piece that the seal sits flush ...

Asked by thor389 about 1 month ago - 1 Answer

1978 Ford F-250 Engine Problem with 100000 miles

Hello. I am at the end of my rope.I hope that you can help. I have a rebuilt 460,which I have done myself.I have been working on cars for ...

Asked by hoecat about 1 month ago - 1 Answer

1994 Nissan Sunny Engine Problem with 200000 miles

My Nissan FB 14 has a GA 15 (DE) engine. The car is auto gear and It doesn't pick up well.Petrol consumption is also very high.Very ...

Asked by Ranbanda about 2 months ago - 2 Answers

2001 Chevrolet Blazer Engine Problem with 126000 miles

Ran diagnostics. OBDII codes P0101 and P0300 returned. Codes continuous. Service Engine light comes on during operation; will go off on ...

Asked by jrivera776 about 2 months ago - 1 Answer

1997 Hyundai Sonata with 197000 miles

HOW TO REPLACE ONE ONLY ROCKER ARM WITHOUT REMOVING CAM SHAFT IN TWIN CAM

Asked by (pending member) about 2 months ago - 1 Answer

1993 Chevrolet Truck Engine Problem with 250000 miles

Changed my like always , was on my way to work noticed the oil pressure was a little low . futher i went lower it got wwhen i stoped at ...

Asked by (pending member) about 2 months ago - 1 Answer

2007 Pontiac Grand Prix Repair Problem with 83000 miles

Shakes will driving... I though it just needed an alignment but I had that done and I still have the same problem! I have been told it could...

Asked by (pending member) about 2 months ago - 1 Answer

2006 GMC C2500 Engine Problem with 170000 miles

Own from birth 2006 GMC with utility body. all services and such performed by same mechanic. Called to inform him of oil pressure steadily ...

Asked by (pending member) about 2 months ago - 1 Answer

2004 Hyundai Sonata Engine Problem with 44000 miles

Had all the belts, water pump, crank seal, cam seal, idler bearings and tensioner replaced , now car vibrates terribly. Could the mechanic ...

Asked by benrussell about 2 months ago - 4 Answers

1988 Chevrolet Corsica with 150000 miles

How To Install Repair Replace Ignition Key Lock Cylinder. Thanks so much.

Asked by (pending member) about 3 months ago - 1 Answer

1998 Oldsmobile Silhouette Engine Problem with 213000 miles

If the car sat on a jack putting the engine on a slant for 4 days in the cold, would this effect the cam bearings? like after day 4 the ...

Asked by (pending member) about 3 months ago - 1 Answer

2002 Jaguar X-Type Noise Problem with 135000 miles

Re:2002 X-type 3.0 135000 miles 5spd. AWD After several attempts to fix a supposed bad connection to the air intake throttle the car is ...

Asked by Gjag about 3 months ago - 1 Answer

1999 Dodge 600 Engine Problem with 145 miles

My car has been making a loud knocking noise from the front passenger side of the engine and when it accelerates it gets louder til it ...

Asked by (pending member) about 3 months ago - 1 Answer

1996 Toyota 4Runner Engine Problem

I need to know the head bolts torque specs and pattern for the v6 please

Asked by alfredm8702 about 3 months ago - 11 Answers

2007 Hyundai Santa Fe Engine Problem with 147000 miles

My oil was very low and oil light cam on and cars temp went to hot and now I have ticking sound coming from engine and I did full oil change...

Asked by (pending member) about 4 months ago - 1 Answer

2002 Saturn SL2 Engine Problem with 160000 miles

How much work is it to replace a head gasket on the above mentioned car for an average mechanically inclined person? and what all will I ...

Asked by (pending member) about 4 months ago - 1 Answer

2006 Chevrolet Monte Carlo Steering Problem with 12700 miles

A very short while after driving yesterday (like 50 yards) my brake light and traction control light came on and stayed on. I got a message ...

Asked by fogertyb about 4 months ago - 1 Answer

1988 Chevrolet Cheyenne Engine Problem with 107000 miles

1988 chevy cheyenne 3500 w/ 350 4 speed tranny. my truck ran fine last night with slight lifter tick like usual-(once it warms up) and today...

Asked by colten_simonds about 5 months ago - 1 Answer

1999 Pontiac Montana Brakes Problem with 180000 miles

1st real cold morning,started van,heard whining sound(I thought maybe pwrsteering or altn)it would get louder with acceleration,did this for...

Asked by mik4rd about 5 months ago - 6 Answers

1972 Holden HQ

I have rebuilt 253 v8 engine and the oil pressure drops at idling speed 500rev/min to 0 pick up to15 psi 600rev/min when put auto in gear ...

Asked by (pending member) about 5 months ago - 1 Answer

2006 Vauxhall Zafira Engine Problem with 65000 miles

HI I own Zafira B 1,9 cdti 150 bhp. Got a black smoke (when engine warms up gets little grayish) when accelerating. Also fuel consumption ...

Asked by kristapsl about 5 months ago - 1 Answer

1994 Chevrolet Camaro with 80000 miles

How to replace the blinker arm

Asked by (pending member) about 5 months ago - 1 Answer

1995 Mazda b3000 Electrical Problem with 175000 miles

My check engine lights is on code says cam position sensor this is a 1995 mazda B3000 3.0 4x4 truck question the sensor is at the back of ...

Asked by (pending member) about 5 months ago - 1 Answer

1997 Ford Mustang Engine Problem with 150 miles

I am puting parformance comp cams in my mustang but they are used so i was wondering how to go about geting rid of wear patternson the cam ...

Asked by (pending member) about 6 months ago - 1 Answer

1989 Pontiac 6000 Repair Problem with 16000 miles

I'm having trouble with inserting a key into the ignition. The locksmith said the ignition needs to be replaced. How do I go about doing ...

Asked by (pending member) about 6 months ago - 1 Answer

1992 Toyota Windom Noise Problem with 119000 miles

I have a loud rattling noise when at low rev usually from idle til 2600rpm, goes away as the revs build. it sounds like is coming from down ...

Asked by kanemcconnell about 6 months ago - 1 Answer

2003 Subaru WRX Engine Problem with 200000 miles

Hi, I got a question about the bolt on the cam bearing caps. We broke a bolt on one of the caps installing it. It's torque is 14.5 LBS., we ...

Asked by (pending member) about 6 months ago - 3 Answers

1976 Jeep CJ5 Engine Problem with 200000 miles

I have a 304 engine. when it starts up it will have 55 pounds of oil pressure, when it warms up it has about 20 to 25 pounds of pressure. ...

Asked by andrew1985 about 6 months ago - 5 Answers

2004 Renault Espace Noise Problem with 142000 miles

Hi I have a Renault Espace 2004 2.2 dci 04 plate. Ive had it since March and bought it not knowing it have a cracked manifold and was ...

Asked by (pending member) about 7 months ago - 2 Answers

1972 Ford F-100 Engine Problem with 100 miles

Hello good evening. I was wondering if anyone could help me please, i recently finished rebuilding my first engine, im a student. I rebuilt ...

Asked by (pending member) about 7 months ago - 2 Answers

2000 Daewoo Leganza Engine Problem with 186000 miles

I want to change the timing belt, what other parts do I need to change, such as water pump, etc.

Asked by charlestuck about 7 months ago - 1 Answer

1997 GMC Yukon Engine Problem with 22643 miles

Can i get to the cam bearings through oil pan

Asked by (pending member) about 7 months ago - 1 Answer

2001 Volvo S80 Engine Problem with 143000 miles

I'm turning the engine manually and l pull out #5 spark plug and notice theres oil in the cylinder almost to the opening for the spark plug...

Asked by danachu about 7 months ago - 3 Answers

2003 Mitsubishi Outlander Engine Problem with 90000 miles

We have managed to narrow it down to the belt but cant find a repair manual

Asked by gingergrayshinn about 7 months ago - 1 Answer

1992 GMC S15 Engine Problem with 250 miles

My 1992 GMC S15 4.3 TBI Blazer just started running rough and very rich won't accelerate no power. The engine was completely re built 18K ...

Asked by wa7spy about 8 months ago - 8 Answers

1972 GMC Acadia Engine Problem with 71000 miles

I have a 1972 GMC truck with a problem. It runs fine when the engine is cold, but when the engine warms up the engine starts to surge when I...

Asked by dragtruck about 8 months ago - 2 Answers

1983 Mercedes Benz 300se Engine Problem with 98500 miles

Hi there, I would be really grateful if you could send me the instructions to change the camshaft on a Mercedes 300SE 1983, as i cannot seem...

Asked by amcconnon about 8 months ago - 1 Answer

1999 Toyota Camry problem with 195000 miles

There are two marks on the camshaft seal cover. One is a straight line up and down at what I would call the top. The other is a dimple like ...

Asked by raymondwebster about 8 months ago - 10 Answers

2006 Dodge Charger Engine Problem with 50000 miles

I have a 06 dodge charger with a 2.7l engine, I have changed bearings, water pump and a few intake valves. Changed intake valves twice due ...

Asked by vandeon about 8 months ago - 1 Answer

1994 Toyota Landcruiser Engine Problem with 174 miles

Hi, i have a 94 Land Cruiser, starts with a engine noise, i went to the mechanic and he told me the noise is under valve cover. He said ...

Asked by morcelle about 9 months ago - 4 Answers

1997 Chevrolet Silverado problem with 178000 miles

I just recently put in a crankshaft, main and rod bearings and it went well except I get code P0340 Now. Can I test the cam or crank ...

Asked by j.stieg about 9 months ago - 1 Answer

1996 Buick Regal Engine Problem with 175600 miles

I'm looking for an oil diagram for a Buick 3800 Series II

Asked by Firemnted about 10 months ago - 13 Answers

1996 Buick Regal Engine Problem with 175600 miles

I have a lifter tap and I rebuilt the engine about 4000 miles age Does it matter what way the oil hole on the lifters faces? I had the ...

Asked by Firemnted about 10 months ago - 5 Answers

1996 Buick Regal Engine Problem with 191000 miles

3800-2 Engine rebuilt about 3500-3700 miles ago. I did not replace the cam or lifters. The cam checked out like new The lifters in question ...

Asked by Firemnted about 10 months ago - 11 Answers

2000 Jaguar XJ8 Engine Problem with 80000 miles

Started to change out 2nd tensioners, removed cam caps and found passenger side cam was stuck and would not move, since tensioners looked ...

Asked by Maddie22 about 10 months ago - 3 Answers

Related Topics