Spider Gears Questions
- 1996 Ford Ranger Drivetrain Problem with 199000 miles
- Need to know how to replace spider gears in rearend cant get the gears out the gears are chewed up and i need to replace but i cant get them...
- Asked by tellicoblue about 1 month ago - 1 Answer
- 1996 Chevrolet Cheyenne Engine Problem with 110000 miles
- Engine starts and idles fine......sputters and backfires when in gear and accellerating. I can accellerate gradually but will not after ...
- Asked by fenn49 about 2 months ago - 7 Answers
- 1996 Chevrolet Suburban with 200000 miles
- HOW TO CHANGE SPIDER GEAR
- Asked by (pending member) about 2 months ago - 1 Answer
- 1998 Ford Crown Victoria with 150500 miles
- My car started makeing a clicking noise now it does it when i make a turn either way unless i coast around the corner without tuchin the gas...
- Asked by tyler6107 about 2 months ago - 1 Answer
- 2002 GMC Sierra Drivetrain Problem
- Can i use the diff internals from a 97 chev rear an put it in a 2002 chevy the truck rearends are diffrent 1 is 6 lug the other is 5 an 1 is...
- Asked by (pending member) about 2 months ago - 1 Answer
- 2007 Ford F-150 Drivetrain Problem with 120000 miles
- When going around corners the rear wheels or rearend makes a fairly loud whining noise .does not do it when cold and no noise at all when ...
- Asked by scottysws about 2 months ago - 3 Answers
- 2003 Kia Sorento Drivetrain Problem with 140000 miles
- When cv axel is removed from transmission is there any shims or gears that could shift out of place
- Asked by (pending member) about 2 months ago - 1 Answer
- 1995 Chevrolet Blazer Engine Problem with 166000 miles
- Symptoms that began all of a sudden, when engine would warm up to running temp motor would begin sputtering like it was starving for fuel, ...
- Asked by dRhanson63 about 3 months ago - 1 Answer
- 1995 Chevrolet Blazer Engine Problem with 166 miles
- Symptoms that began all of a sudden, when engine would warm up to running temp motor would begin sputtering like it was starving for fuel, ...
- Asked by dRhanson63 about 3 months ago - 0 Answers
- 2004 Ford Expedition Drivetrain Problem with 106000 miles
- How hard is it to change the spider gear in my 2004 Ford Expedition?
- Asked by mcdonald476 about 3 months ago - 0 Answers
- 2001 Chevrolet Suburban Drivetrain Problem with 232 miles
- Does it matter if i put a 3.73 or a 4.10 rear axle in my suburban cause my spider gears just went out
- Asked by joseph cope about 3 months ago - 1 Answer
- 1996 Chevrolet Blazer Engine Problem with 117000 miles
- I have a 96 Chevy Blazer 4.3 Vortec Spider Injection 4x4. Ive been The past 3 months trying to figure out this dreadfull random misfire code...
- Asked by bck2themoney about 4 months ago - 1 Answer
- 2003 Chevrolet S-10 Engine Problem with 118000 miles
- I have a 4.3 liter v-6 vortec motor and a couple months ago I was having misfires on cylinder 3. I traced down the plug and wire and it was ...
- Asked by (pending member) about 4 months ago - 1 Answer
- 1985 Toyota Pickup with 232000 miles
- I have a detroit locker with 4.88 gears in both axles . the rear axle lately has been slamming and banging extreemly hard lately. could the ...
- Asked by (pending member) about 5 months ago - 1 Answer
- 1999 Ford Mustang with 120000 miles
- I was changing the spider gears in my reaend when i was done my back drivers side wheel is seized the e brake light was on took caliper off ...
- Asked by (pending member) about 5 months ago - 1 Answer
- 1997 Saturn SC2 Engine Problem with 265000 miles
- I have a 1997 Saturn SC2. It has over 260,000 miles on it. I just heard a metallic crack or snap sound, and the spedometer stopped working...
- Asked by (pending member) about 5 months ago - 1 Answer
- 1992 Jeep YJ Drivetrain Problem with 220000 miles
- What causes my spider gears to grind and chip and break?
- Asked by More work then play about 6 months ago - 1 Answer
- 2001 Dodge Dakota Drivetrain Problem with 136000 miles
- How do you remove the pass. front axle shaft on a 2001 Dakota 4wheel drive? It won't just pull out. I have the diff. cover off but can't get...
- Asked by (pending member) about 6 months ago - 0 Answers
- 1997 Ford Expedition with 150000 miles
- When I pulled away from a stop sign, I heard a pop come from the rear end and the truck started shaking. Now when I drive it I have to take ...
- Asked by (pending member) about 6 months ago - 1 Answer
- 1994 Pontiac Firebird Drivetrain Problem with 231000 miles
- I need to know my exact rear axle size and spline number for this car before i replace the spider gears with a mini spool, there is a ton of...
- Asked by jessehdorman about 7 months ago - 13 Answers
- 2000 Ford Ranger Drivetrain Problem with 141000 miles
- I hear a grinding sound couple times a week comming from my rear axle i think ,this happens when in 2 wheel drive,the truck is a 4x4 , ...
- Asked by (pending member) about 7 months ago - 1 Answer
- 1992 Honda Accord Drivetrain Problem with 407800 miles
- Weird problem going on with tranny. what had happened is that when i replaced my rack and pinion and tried to slip in the passenger axle, i ...
- Asked by steveal01 about 7 months ago - 8 Answers
- 2005 Chevrolet Suburban Repair Problem with 120000 miles
- Having trouble removing the axels from my 2005 suburban. Already removed the pin in the differential. However the axel won't push over ...
- Asked by Scottk32 about 7 months ago - 1 Answer
- 2000 Dodge Dakota
- How do I remove the rear differential gear?
- Asked by (pending member) about 7 months ago - 2 Answers
- 1988 Ford Explorer Drivetrain Problem with 155000 miles
- When I turned the 4WD hi on my Explorer 4 ltr SOHC, the right front wheel when turning left from a stop the wheel seems to be sluggish, ...
- Asked by frankermel about 7 months ago - 4 Answers
- 2001 Chevrolet S-10 Drivetrain Problem with 133000 miles
- On 4wheel drive the rear passenger axle shaft can move in and out about 1/8 th to 1/4 in. is this still ok or is there a problem with the ...
- Asked by (pending member) about 7 months ago - 1 Answer
- 1999 Mitsubishi Eclipse Drivetrain Problem with 175000 miles
- 1999 mitsibishi eclips spider , 2.4 engine auto transmission, no codes on reader and no gears in all positions on the shifter , changed oil...
- Asked by roncd about 8 months ago - 2 Answers
- 1994 Chevrolet S-10 Repair Problem with 14500 miles
- 4.3 Vortec,60,000 on engine,just changed spider injection and nut kit,spark plugs,scanned it and shows no codes,starts fine,runs good until ...
- Asked by novaclone about 9 months ago - 5 Answers
- 1997 Dodge Dakota Drivetrain Problem with 196000 miles
- Axles spline are 29 spider gears only have 9 teeth axles are longer than normal.its supposed to be D 35 tag on cover says d 35 but nothing ...
- Asked by michaelhardin about 9 months ago - 1 Answer
- 1996 Jeep Cherokee Noise Problem with 210000 miles
- Today, I was witness to an accident, so I pulled off the side of the road into sand. When I went to leave the scene of the accident, I ...
- Asked by Delaney_0513 about 9 months ago - 7 Answers
- 2003 Jeep Liberty problem with 72000 miles
- Had rear axle seal replaced.....new fluid... now i have clunking when stepping on brake ...sound in the rear......emergency brake not ...
- Asked by Mark Millron about 11 months ago - 7 Answers
- 1999 Acura RL Noise Problem with 293000 miles
- It made a loud noise when i accelerate what is it let me know how to fix it.
- Asked by pmoushon14 about 1 year ago - 5 Answers
- 1999 Ford F-150 Repair Problem
- Replaced rear brakes and shocks on a 1999 ford f150 and while doing so spider gears fell had to reinstall gears and differential. Put all ...
- Asked by dadtr4uck about 1 year ago - 1 Answer
- 2001 GMC Sonoma Repair Problem
- Need to remove spacer from axel so i can get c clip out
- Asked by jwatts12 about 1 year ago - 3 Answers
- 1999 Ford F-150 Drivetrain Problem with 16900 miles
- It was working 2high to4high got under it with test light because it would not come out of four wheel now stuck in four wheel high
- Asked by dalekern about 1 year ago - 1 Answer
- 1992 Chevrolet Van Repair Problem with 19000 miles
- I was told i have to take the back axle off on each side to be able to take the old seal off and replace it with a new one. Is this correct...
- Asked by Starzypan777 about 1 year ago - 1 Answer
- 1998 Chevrolet Silverado Electrical Problem with 244000 miles
- I have a 98 Silverado. We have rebuild the 5.7 vortec motor and the 4L60E transmission. Everything is stock in the motor except we went with...
- Asked by rickyandtina about 1 year ago - 1 Answer
- 2005 Dodge Dakota problem with 96000 miles
- Rear axle repair
- Asked by Jared Ramin about 1 year ago - 1 Answer
- 1996 Chevrolet Cavalier Drivetrain Problem with 163000 miles
- The tranny will go in gear but the drive whell won't rotate
- Asked by Jeremiah Martin about 1 year ago - 3 Answers
- 1996 Chevrolet Lumina problem
- I can't find these without a parts number.
- Asked by doryswife about 1 year ago - 1 Answer
- 1985 Dodge Truck with 122 miles
- Best and most affordable way to freshen up my 9.25 rearend on 4x4 w/ a 12 bolt cover. when placed in drive it clanks , nothing to do with u-...
- Asked by jamisu about 1 year ago - 8 Answers
- 1997 GMC Sierra Drivetrain Problem with 200000 miles
- Rear end locking up
- Asked by jclews about 1 year ago - 2 Answers
- 1978 Fiat 124 problem with 113500 miles
- I am better versed on American cars and my 78 Fiat Spider is givingn me fits. It has ran fine for several years but developed a starter ...
- Asked by spidersteve78 about 1 year ago - 1 Answer
- 1986 Pontiac Fiero problem with 97696 miles
- I have a 1986 pontiac fiero es v4 2.8 l. and today it started being very hard to shift into first and sometimes all of the gears, can ...
- Asked by Roberto1 about 1 year ago - 1 Answer
- 1997 GMC Sonoma problem with 180000 miles
- THE TRUCK RUNS BUT HAS NO ACCELERATION I HAVE REPLACED THE MAP SENSOR AN THE CAMSHAFT POSION SENSOR AN ALL THE INTAKE MANAFOLD GASKETS ...
- Asked by CHRISTESTER about 1 year ago - 2 Answers
- 1984 BMW 733i problem with 25000 miles
- I have a 1984 bmw 733i i need two spider gears but the dealer ship dont make then no more what do i do
- Asked by lackey 420 about 1 year ago - 2 Answers
- 1975 Toyota Landcruiser problem
- I have a problem with the clearances between the pinion shaft that goes between the spider gears, they seem to be too tight even without the...
- Asked by Hurricane about 2 years ago - 3 Answers
- 2000 Ford F-150 problem with 265000 miles
- I have a 2000 ford f150 4.6l and i am trying to remove the rear outer axle seal.I already removed the differential cover took out the ...
- Asked by david.r.hart about 2 years ago - 1 Answer
- 1984 GMC S15 problem
- 1984 GMC S15 pickup, how do the rear axles come out to replace the seals?
- Asked by laserbera about 2 years ago - 1 Answer
- 2000 Chevrolet Astro problem
- I have a rear end out of a 2000 chev blazer and am wondering how to remove both axles and all the gears inside the case i will be making the...
- Asked by fergusonbrad about 2 years ago - 1 Answer
Related Topics
Got a Car Question?
Automotive repair can be puzzling without the right information. Fortunately, 2Carpros was created to help people with everyday repair problems in mind. New systems are being introduced yearly, instruction is needed to complete a service or repair. We offer access to a panel of ASE and manufacturer specific certified mechanics that are dedicated to guide novices and experts alike in any repair. After a detailed question enters our system it's filtered to a specializing mechanic. Once the problem has been indentified our technician will respond with diagrams, instruction and any additional information required. 2Carpros is a completely FREE service. Our technicians are compensated through donations and advertising revenue.
Ask a QuestionNot Sure Where to Start?
Most car repair is basic and straight forward. Unfortunately auto related problems such as "electrical" and "engine performance" issues can be complicated. These styles of problems can create confusion which leads to unnecessary repairs. These mistakes not only consume resources they waste time as well. Having the correct instruction can pinpoint the malfunction while generating the proper repair procedure. Our first things to check section includes step by step "do it yourself" troubleshooting guides that offer video with illustrations showing hands on interaction while providing tips of the trade for a successful car repair.
First Things to Check