Rocker Shaft Questions

1983 Dodge Ramcharger Engine Problem with 10000 miles

Yes i am trying to find out what the foot pound torque is on my dodge ramcharger its a 1983 and engine size is a 360 small block i am ...

Asked by geldamesh about 4 days ago - 4 Answers

2001 Saturn SL1 Engine Problem with 100000 miles

How do you change the valve seals and do you have a diagram so I can see how to get to the valves? Really appreciate help Rob

Asked by Seranablue about 1 month ago - 3 Answers

1993 Chrysler Other Repair Problem with 100000 miles

Me again i suck at this .i got a jeep 5.2 my rotor button wont rotate. checked oil pump .cam sensor. distributor .what drives the ...

Asked by cuntree about 1 month ago - 1 Answer

2006 Chrysler 300 Engine Problem with 250000 miles

5.7ltre engine bad miss in drivers side bank 2nd cylinder from front of engine . Compression test showed 0 psi compression.At 1st it had a ...

Asked by john conlan about 1 month ago - 3 Answers

2003 Hyundai Accent Engine Problem with 20 miles

I car was giving a noice so my connecting rod was damaged ,,which i replaced with new one after that i put new slip ,began and gas ket ...

Asked by (pending member) about 1 month ago - 1 Answer

1997 Hyundai Sonata with 197000 miles

HOW TO REPLACE ONE ONLY ROCKER ARM WITHOUT REMOVING CAM SHAFT IN TWIN CAM

Asked by (pending member) about 2 months ago - 1 Answer

2001 Fiat Seicento Engine Problem with 67000 miles

I have a bad oil leak fom engine, i have replaced crank shaft oil seal, replaced the sump and rocker cover gasket but still leaking there is...

Asked by (pending member) about 3 months ago - 1 Answer

1992 Eagle Summit Repair Problem with 320000 miles

I need to know how to replace camshaft seal on my 1.8 fwd eagle summit dl wagon

Asked by (pending member) about 4 months ago - 1 Answer

2002 Chrysler 300 Engine Problem

Hoe do remove lifters from rocker assembly

Asked by (pending member) about 5 months ago - 2 Answers

1999 Honda CRV Engine Problem with 150000 miles

I have noisey rockers on cold engine. Rocker clearances have been set three times to .007 E and .004 I and they were done cold,. Problem ...

Asked by (pending member) about 6 months ago - 1 Answer

1985 Isuzu Truck Engine Problem with 122000 miles

I need directions and a diagram of how to torque my valve springs and what springs need what torque

Asked by isuzu8595 about 6 months ago - 17 Answers

1999 Chevrolet Suburban Engine Problem with 175 miles

1999 chevy, sub, k1500 (1/2 ton, 4x4) Engine code: R, 5.7 L Drivers side head removed, valve bent, replaced at machine shop. Rocker arms ...

Asked by Bill For about 7 months ago - 8 Answers

2001 Saturn SL2 Electrical Problem with 120000 miles

So i took my Saturn in for a routine Fluid change. Local Shop was running a special where they replace all your car fluids. While there i ...

Asked by pelkeychr about 8 months ago - 5 Answers

2004 Dodge Ram Engine Problem

I have a 04 Dodge Ram 3.7, and I just replaced the right cylinder head because the #2 rocker tower was broken, prior to removing the timing ...

Asked by Mikes mobile mechanic service about 10 months ago - 5 Answers

1997 Honda Civic Engine Problem with 175000 miles

First off, I want to let you all know that the car was running with a half-dead cylinder to begin with. However, it was driving decently. ...

Asked by Masowai about 11 months ago - 11 Answers

1964 Mercury Comet problem with 200000 miles

Im trying to correctly assemble(tighten) the rocker arms on a 289. Ive followed chiltons(which says tighten to 17-23lbs when lifter is at ...

Asked by shjonmc about 12 months ago - 6 Answers

1998 Hyundai Sonata problem

I need help urgently

Asked by argey about 1 year ago - 1 Answer

1997 Saturn SW1 Engine Problem with 140000 miles

Details are in ask a question...

Asked by saturnsw1 about 1 year ago - 2 Answers

1999 Buick Century Engine Problem with 102000 miles

I replaced the intake manifold gaskets, 4 exhaust push rods, two rocker arms and now I have multiple misfire and the car runs like crap. I ...

Asked by bcmullen95 about 1 year ago - 6 Answers

2005 Chrysler Pacifica Noise Problem with 60000 miles

I have heard Pacificas have a history of bad lifters. Could that be it?

Asked by mtmarmots17 about 1 year ago - 11 Answers

1991 Mazda b2600 Repair Problem with 246000 miles

I have removed the valve cover, but now i dont know what the next steps are to remove and replace the 2 worn out hydrolic valve lifters. ...

Asked by tebo82 about 1 year ago - 1 Answer

1990 Chevrolet Truck Engine Problem

The engine in my truck is misfiring badly. Don't know if it could be due to a cracked distributor cap or a bad cam shaft.

Asked by GordoMI about 1 year ago - 0 Answers

2007 Chevrolet Silverado Engine Problem with 190000 miles

I HAVE A 2007 CHEVY 1500HD 5.3L V-8 NON ACTIVE FUEL MANAGEMENT ENGINE GIVING ME A #1 CYLINDER MISFIRE. THE PROBLEM IS THE #1 INTAKE VALVE ...

Asked by JEFFJ about 1 year ago - 4 Answers

1999 Chevrolet Suburban Engine Problem with 260000 miles

New crank shaft, cam shaft, roller rockers, all aluminum 202 valves, oil pump has a fit where the truck will not shift, the gauges go wild ...

Asked by jonathanmcclenathan about 1 year ago - 0 Answers

1999 Chevrolet Trailblazer Noise Problem with 20000 miles

My car was making a ticking noise, so I checked the oil. The dipstick didn't have anything on it. I put 2 quarts of oil in it went over just...

Asked by azn about 1 year ago - 0 Answers

1989 Mercedes Benz 190e problem with 160000 miles

190E hydraulic tappet repair

Asked by FastFree about 1 year ago - 1 Answer

1989 Mercedes Benz 300se problem with 200000 miles

How do you replace the hydraulic lifters on a 1989 mercedes 300SE? On this same car do you need to adjust the valves? If I could have ...

Asked by drproud about 1 year ago - 7 Answers

1998 Chevrolet S-10 problem with 115000 miles

1998 s-10 2.2 auto 2wd. It started and ran went out to restart the next day and the push rods bent. Installed straight ones ran it and bingo...

Asked by midnight75 about 1 year ago - 1 Answer

1995 Pontiac Bonneville problem with 260000 miles

New rebuild from shop - no oil except in pan and filter - have not driven any miles. No help from shop - pressure primed at shop? - filter ...

Asked by quedawg65 about 1 year ago - 10 Answers

1991 Ford Tempo problem

I have a '91 Ford Tempo that I recently replaced the oil pan on. It ran fine for a day or so then started knocking. It's a pretty steady ...

Asked by damekC about 1 year ago - 3 Answers

1977 Dodge Truck problem

What quantity of antifreeze/water should my 1977 dodge D200 w/ 440 take?I replaced radiator with oem match.Chilton book says 16 qts but ...

Asked by the big red one about 1 year ago - 4 Answers

2001 Honda Accord problem with 105 miles

Car: 2001 honda accord v6 (f30a1) ex problem: over torqued the valve adjusting screws on the rocker arm while doing the Valve Clearance...

Asked by Justadriver about 2 years ago - 13 Answers

1995 Land Rover Discovery 2 problem with 210000 miles

My Landrover Discovery Series II has timing belt problems. The teeth on the belts keep getting ripped off – even off a genuine belt. ...

Asked by niallwatson about 2 years ago - 0 Answers

1986 Nissan Truck problem

How do i replace the timing belt on an 86 nissan pick up ?

Asked by chucho about 2 years ago - 0 Answers

1988 Dodge Ramcharger problem

I'm going to be rebuilding an engine in my 1988 dodge ramcharger. Its my first dodge engine rebuild. Done Chevy Engines most of my life. I ...

Asked by Jon T. Kaufman about 2 years ago - 3 Answers

1990 Nissan Pathfinder problem

I am changing my timing belt on a 1990 nissan pathfinder. My aligning mark at the bottom seems to be straight down and the mark on the belt...

Asked by whitanders about 2 years ago - 0 Answers

2000 Nissan Pathfinder problem with 234800 miles

Yes hi, my questeion is how can i put my nissan pathfinder on time . the time belt broke and it seems like no one know whow to put it on ...

Asked by MARICEL about 2 years ago - 0 Answers

2003 Ford Explorer problem with 100000 miles

I have a knocking noise that is in the drivers side of the engine, it starts when the car starts and while in idle, and durring acceleration...

Asked by dnjamieson about 2 years ago - 1 Answer

1987 Mazda b2200 problem

1987 Mazda b2200 Theres a loud clacking when I start the truck. It quietens just a little after a while. I removed valve cover and ...

Asked by tomcat642 about 2 years ago - 0 Answers

1992 Plymouth Acclaim problem with 110000 miles

1992 Plymouth voyager mileage: 110K. Help...after replacing our van's timing chain and radiator, our mechanic said the tapping noise I am ...

Asked by 2CarPros-Archives about 2 years ago - 1 Answer

1994 Mazda 323 problem

Engine Mechanical problem 1994 Mazda 323 4 cyl Two Wheel Drive Manual 350000 miles I have a Mazda 323 200i Hatch DOHC, the fuel ...

Asked by Zahid7863 about 2 years ago - 1 Answer

2004 Hyundai Santro problem

Engine Performance problem 2004 Hyundai Santro 4 cyl Two Wheel Drive Manual 52339 miles Hi, I am at a situation where the registered ...

Asked by arjun_laha about 2 years ago - 0 Answers

1992 Suzuki Sidekick problem

Engine Mechanical problem 1992 Suzuki Sidekick 4 cyl Four Wheel Drive Automatic 110,00 miles I rebuilt my engine. I had NAPA rebuilt ...

Asked by jsanta about 2 years ago - 1 Answer

1993 Mitsubishi 3000GT problem

Engine Performance problem 1993 Mitsubishi 3000GT 6 cyl Front Wheel Drive Automatic 110000 miles We lost 3 rocker arms on engine, so we...

Asked by Larryscarconnection about 2 years ago - 0 Answers

1994 Toyota Corolla problem

Engine Cooling problem 1994 Toyota Corolla 4 cyl Two Wheel Drive Automatic 217278 miles What could be the cause of the oil leaking

Asked by Knolege about 2 years ago - 4 Answers

1990 Cadillac Deville problem

Engine Performance problem 1990 Cadillac Deville V8 Front Wheel Drive Automatic 74000 miles I purchased a 1990 Cadillac. This car had ...

Asked by Frank Emmitte about 2 years ago - 1 Answer

1995 Chrysler Cirrus problem

Engine Mechanical problem 1995 Chrysler Cirrus 6 cyl Two Wheel Drive Automatic 102k miles Things I have tried and found to be within ...

Asked by poet042005 about 2 years ago - 5 Answers

1992 Eagle Summit problem

Engine Mechanical problem 1992 Eagle Summit 4 cyl Front Wheel Drive Automatic WHAT IS THE TORQUE SPECS FOR ROCKER ARM AND CONNECTING ...

Asked by PEDRON PALE about 2 years ago - 1 Answer

1987 Nissan Truck problem

Engine Mechanical problem 1987 Nissan Truck 4 cyl Two Wheel Drive Automatic 225000 miles I have a Z24i, 4cylinder, throttle body, ...

Asked by surferpat about 2 years ago - 0 Answers

1988 Mercedes Benz 190e problem

Engine Performance problem 1988 Mercedes Benz 190e 4 cyl Front Wheel Drive Automatic 270,00 miles THIS CAR HAS SERIES OF PROBLEM THE ...

Asked by AECTOR about 3 years ago - 0 Answers