2000 Volvo S40

2000 VOLVO S40
113,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
JOANNE04090
  • MEMBER
  • 2 POSTS
I have a 2000 volvo s40 and we had to replace the dash board. When we were putting things back in place the radio came up asking for a code and the wrong code was entered now all we get when we turn the radio on is OFF. How can we get it to come up to the code section again? I have the right code this time. Is there a way to reset it?
Sep 8, 2009 at 5:51 PM
Advertisement
Avatar
JIS001
  • CAR REPAIR CONTRIBUTOR
  • 3,412 POSTS
Yes you can reset it. Leave the ignition key on and radio on for several hours until you code the "CODE" message again. You may want to have a battery charger hooked up set on low for this procedure. Good luck.
Sep 8, 2009 at 9:07 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.