1988 Toyota Pickup Repair Question
Topics covered: Engine, Idle air control valve, Distributor.
Mileage: No information provided.
Mileage: No information provided.
Asked on October 27, 2010
1988 Toyota Pickup engine will run in idle but stalls when
Engine Performance problem
1988 Toyota Pickup 4 cyl Four Wheel Drive Manual 200k miles
while driving the engine all at once would not accelerate at all, it will rubn in idle but when accelerator is pushed it stalls, rotor, distributor cap and iignition wires were replaced to no change. Any ideas how to proceed next would be greatly appreciated.
1988 Toyota Pickup 4 cyl Four Wheel Drive Manual 200k miles
while driving the engine all at once would not accelerate at all, it will rubn in idle but when accelerator is pushed it stalls, rotor, distributor cap and iignition wires were replaced to no change. Any ideas how to proceed next would be greatly appreciated.
Asked by garylkAnswer
Replied on October 27, 2010
Have you checked fuel pump pressure? Have you checked the idle air control valve?
Replied on October 28, 2010
On the 1988 4 cylinder there is no place I can find to connect a pressure quage. Any ideas how connect to check the fuel pressure? Let me know, thanks!!
Regarding the idle air control valve, my book doesn't show it. Where is it located? Near the throttle position sensor?? Any guidance would be appreciated.
Replied on October 28, 2010
If there is no port, you need a T to place in the fuel line. As far as the IAC, here is a picture of it.
