Engine will not turn over?

Tiny
MZAGEL
  • MEMBER
  • 1996 NISSAN 300ZX
  • 75,000 MILES
It just won't start. 1 I can get in drive it around, go to work, let it sit till the end of the day, completely dead, no lights in dash, no cranks, nothing completely dead, new battery, check altanator, what could it be. Dead silence.
Do you
have the same problem?
Yes
No
Thursday, December 20th, 2012 AT 12:30 AM

28 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Sounds like you have a short circuit within the electrical system that's draining the battery-Refer to this link for more information: https://www.2carpros.com/articles/car-battery-dead-overnight

This guide can help as well

https://www.2carpros.com/articles/starter-not-working-repair

Was this
answer
helpful?
Yes
No
Thursday, December 20th, 2012 AT 1:18 AM
Tiny
2CP-ARCHIVES
  • MEMBER
  • 4,544 POSTS
  • 1992 NISSAN 300ZX
  • 140,000 MILES
Hey, I have a quick question. I own a 92 nissan 300zx, and I redlined it pretty badly friday night. A couple of minutes later, a clicking noise started and acceleration started to decrease. Soon after my car died out, and smoke came out from under my hood. It wont crank and loses power. I know that my engine is blown, but I need to know what I can do to fix it.

Ps getting a new engine is out of the question.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Cant tell this till it is removed, torn down and inspected.

Roy
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
It sounds like something let go in the motor whether it is a piston or a valve. When over revving occurs, internal damage can only be determined with a tear down to see what has failed. It is not an easy answer as I am here and you are there and I cannot see, touch or hear what is happening.

Roy
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
JOEYBURDETTTE13
  • MEMBER
  • 2 POSTS
  • 1991 NISSAN 300ZX
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 192,000 MILES
1991 nissan 300zx engine turns over and almost starts but will not run. Its getting fuel through the lines and pump is pumping, injectors are pulsing, I dont think its getting enough fuel to the plugs. Please help.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the fuel pressure if its within specs and also are you getting spark
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
JOEYBURDETTTE13
  • MEMBER
  • 2 POSTS
Thanks. Im getting fire and now its getting fuel but still isnt starting it seems like it wants to but it wont?
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
You didn't mention the fuel pressure reading-injector/s pulsing-check the valve and ignition timing
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
MIKESALMON
  • MEMBER
  • 1 POST
  • 1988 NISSAN 300ZX
  • 6 CYL
  • 2WD
  • MANUAL
  • 160,000 MILES
Car became hard to start, I had to crank for a while to start, now it will not start at all, cranks just fine, but will not fire, acts like no gas to engine
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Cranks but no start condition:

Fuel and Spark:
Get a helper disconnect a sparkplug wire or 2 and ground it to the engine at least 3/16 away from ground -have helper crank engine over-do you have a snapping blue spark? If so-you have a fuel related problem, check the fuel pressure to rule out the fuel filter/fuel pump/pressure regulator and listen to the injector/s are they pulsing or hook up a noid light. No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs, coil's resistances, distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
SOUTHERN LADY
  • MEMBER
  • 1 POST
  • 1986 NISSAN 300ZX
  • 3.0L
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 135,000 MILES
Drove to store and shut it off. When returned, it would turn over fine but not crank.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
https://www.2carpros.com/articles/car-cranks-but-wont-start

You need to find out what is missing causing the non starting. Click above link for more information.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
MARC.SKERRITT
  • MEMBER
  • 3 POSTS
  • 1990 NISSAN 300ZX
Electrical problem
1990 Nissan 300ZX 6 cyl Two Wheel Drive Automatic

This is what's going on. When I turn the key into the accessory, the radio turns on and everything seems fine. When you go to start the car, there is no response. Nothing turns over, there are no clicks, there is absolutely nothing going on. Tried to pull engine codes, but the LED on the ECU doesn't appear to flash. I don't know what else to try. Any help is greatly appreciated.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
SERVICE WRITER
  • MECHANIC
  • 9,123 POSTS
Gives the impression of a bad ignition switch. Power is getting to it, but when moves it does not.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
MARC.SKERRITT
  • MEMBER
  • 3 POSTS
Without applying the break, I shifted from park to neutral and it started no problem. After driving around the block, and there car back in park, it started once again no problem. Neutral safety switch?
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
SERVICE WRITER
  • MECHANIC
  • 9,123 POSTS
That was I was thinking as I read that.

Need a diagram?
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
MARC.SKERRITT
  • MEMBER
  • 3 POSTS
Please and thank you.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
SERVICE WRITER
  • MECHANIC
  • 9,123 POSTS
Bear with me I hit a deer on Sunday and life got a little complicated.
I will be updating this...getting info


https://www.2carpros.com/forum/automotive_pictures/30961_300zx_1.jpg

is tough sometimes.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
SERVICE WRITER
  • MECHANIC
  • 9,123 POSTS
I did a little research. And this is what I learned. There is a relay in the starter circuit, it is located behind the left hand inner fender above the plastic inner liner. Raise the car and remove the back half of the plastic inner fender and look up. Locate this relay and look at the diagram imprinted on the top of it. It is the large blue relay with two harness connectors that plug in to it. This is a real common problem. Substitute a jumper wire in the harness for the contact points of the relay. If the car now starts and you have voltage and ground on the coil side of the relay, then you need relay.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)
Tiny
MREIFEL
  • MEMBER
  • 5 POSTS
  • 1930 NISSAN 300ZX
1994 300ZX, 134,893 miles, non-turbo coupe, Left side driver, manual transmission, V6. When the key is actuated the starter clicks and the dash lights do not go dim but the clock on the console and radio does. The battery is fully charged and does not drain. Will push start easily. Any help would be appreciated.
Thank you.
Was this
answer
helpful?
Yes
No
Sunday, May 17th, 2020 AT 10:49 AM (Merged)

Please login or register to post a reply.

Sponsored links