PROBLEMS WITH CLUTCH PEDAL PRESSURE
Im not too good with hydraulic system. Good on everything else execpt hydraulic. So here it goes.I installed a new master cylinder like 5 months ago, and a new slave 3 days ago, when I bleeded the system I got pressure at first but the next day the pressure was gone, and I didnt see any leaks any where. Does anyone have an idea of what this might be. Also I bought a new master yesterday and installed it, but it does suck the fluid out of the resurvoir, any ideas : idea:
July 11, 2006.
July 11, 2006.
96 ford ranger 2.3l 2wd---hard to get into gear and grinds someitmes going into reverse. replaced- master cylinder, slave cylinder, throwout bearing, pressure plate, clutch disk, ...
3 answers • 1996 Ford Ranger • 192,000 miles
1998 Ford Mustang : I recently took my Mustang GT into a Ford service center for a slipping clutch. They told me that I have a self-adjusting clutch and that the clutch assembly needed ...
1 answer • 1998 Ford Mustang
1995 Nissan Maxima SE. Clutch began slipping about a week ago, then 'broke' loose and went to the floor as I was downshifting from 5th to 4th. Kabam! all the way to the floor and no ...
3 answers • 1995 Nissan Maxima • 270,000 miles
My car has been revving up even while in 5th gear and running on unusually high rpm's when any gas is applied, and it has had a burning brake smell if I drove it very far. Recently,the ...
2 answers • 2003 Mitsubishi Lancer • 130,000 miles