1994 Mazda b2200 Repair Question
Topics covered: Clutch, Clutch master, Transmission.
Mileage: No information provided.
Mileage: No information provided.
Asked on February 5, 2009
1994 Mazda b2200 clutch master cylinder
Transmission problem
1994 Mazda b2200 4 cyl Two Wheel Drive Manual 160000 miles
i just replaced my clutch master cylinder and i am unable to get the air out of the system after bleeding the line where the slave cylinder enters the trans. The clutch has no pressure, it is free floating. why can't i get the pressure built up.
please advise
1994 Mazda b2200 4 cyl Two Wheel Drive Manual 160000 miles
i just replaced my clutch master cylinder and i am unable to get the air out of the system after bleeding the line where the slave cylinder enters the trans. The clutch has no pressure, it is free floating. why can't i get the pressure built up.
please advise
Asked by arty1122Answer
Replied on February 5, 2009
Try bleeding the clutch master cylinder then the slave/servo-if it continues-recheck the master cylinder-Do you have any leak between the master cylinder and slave?
Replied on February 6, 2009
I do not have any leaks in the system from what I can see. The only place I have been bleeding the system is at the slave cylinder. How would i do it at the master.
Replied on February 6, 2009
Crack the line to it -same way as the slave to bleed it-if continues replace it