FOCUS POWER STEERING ARM
I just reccently got a ford focus that had sustained mechanical damage to the driver side suspension and steering. It had a twisted control arm a bent tire rod and a bent steering arm. I replaced all but the steering arm, because when I took the boot off from around where it connects to the steering pump I realized that it is a ball joint and I have no idea how to disconect it. I am currious if I have to take the whole steering pump apart and remove it that was or what. If anyone knows how to help me fix my car I would appreciate it very much. Thank you
July 23, 2006.
July 23, 2006.
Check out the related content below while we wait for the question to be answered by a professional mechanic.
When I'm driving the power steering locks and the wheel gets hard and can't turn,,,so I stop and turn the car off for a few sec.problem solved but the thing is that it's starting to do ...
3 answers • 2006 Chevrolet Malibu • 76,900 miles
Upon getting my car back from being repaired after a passenger side, front end wreck ($4,300.00 PLUS in damages), my power steering seems to be going out. It's sporadic-it has quit ...
3 answers • 2005 Kia Amanti • 78,000 miles
The rack & pinion assembly, power steering pressure and return line assembly, lower ball joints were just replaced on my wife's 2000 Toyota 4Runner and a front end alignment performed...
1 answer • 2000 Toyota 4Runner • 165,000 miles
I have a 2002 Altima and I’m replacing the steering gear. I have everything ready to remove but I’m unable to disconnect the steering gear from the steering column. I have ...
8 answers • 2002 Nissan Altima • 150,000 miles