1999 Ford Explorer 4 wheel drive module

1999 FORD EXPLORER
118,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
GARY G. DEAN
  • MEMBER
  • 1 POST
My 4 wheel drive high and low light flashs on and off 6 times and then stops for a while and then does it again. When I try to ingage the 4 wheel drive switch I have no 4 wheel drive. I have been told this is the module, and it is located behind the glove box. Any one know how to get at this part and how to remove it?
Oct 19, 2009 at 6:00 PM
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Hi Best action is have trans scanned to diagnosis fault with a scan tool as in pic.


https://images.2carpros.com/forum/automotive_pictures/198357_Graphic_192.jpg

When you get results post and will advise. The GEM is located behind radiod console. Hope this helps Thnaks for donate
Oct 21, 2009 at 8:52 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.