2000 BMW 323

2000 BMW 323
134,000 MILES • 6 CYL • 2WD • MANUAL
Avatar
FLGOMEZ
  • MEMBER
  • 2 POSTS
I have a P0441 code on my car did not pass emission test I found a broken house and I fix it then I reset the code a week a go I wan to take to the emission test aging but when i scan I have no DTC pressent
I drive like 120 miles did you know if I did not complete a Driving Cycle?
Jan 8, 2010 at 3:03 PM
Advertisement
Avatar
DOCHAGERTY
  • CAR REPAIR CONTRIBUTOR
  • 9,606 POSTS
To set the monitors: 1. No faults in memory 2. Tank ¼ to ¾ full 3. Start from cold and allow vehicle to idle long enough for the secondary air injection to run to completion. Usually about 3 minutes should do it. 4. Drive the car normally, however do not exceed 3000 RPM. Freeway cruising is good (you can cruise the freeway and not go over 3k rpm) 15 minutes of total time on the freeway has almost always set most of or all the monitors for me.
Jan 9, 2010 at 6:30 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.