afe coldair induction system

AUDI A4
Avatar
MICK BARRON
  • MEMBER
  • 2 POSTS
I just installed an AFE Coldair Induction System
on my 2003 Audi A4 1.8t, everything seems to be fine, however the check engine light stays on, i believethis is because of the increased air flow, however,i would like to be able to turn the light off...
any suggestions
Apr 18, 2007 at 8:33 AM
Advertisement
Avatar
2CARPRO JACK
  • CAR REPAIR CONTRIBUTOR
  • 11,533 POSTS
Are you sure there are no vacuum leaks between the Mass Airflow Sensor and the engine. Is the Air Intake Temp Sensor in the induction. Doubt if more air will set a ligh unless the PCm cant compensate for it for some reason
Apr 18, 2007 at 10:13 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.