I recently change the water outlet on my 2

RICHARDVEGA

MEMBER
2008 DODGE CHARGER
75,000 MILES

I recently change the water outlet on my 2.7 liter I had to remove the upper manifold to be able to put the new water outlet after I had change the part I notice my heater also. Is not working did I do something wrong?

Image (Click to make bigger)

Wednesday, November 14th, 2012 AT 1:35 PM

3 Replies

HMAC300

MECHANIC
48,601 POSTS

Klthe heater doesnt' work meaning what? No hot air? What temp stat is it and was it installed correctly. Does the blower not work? Check fues and relay s in underhood fuse box.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Wednesday, November 14th, 2012 AT 3:01 PM

RICHARDVEGA

MEMBER
2 POSTS

Yea the heater no hot air, plus my temp needle isn't working also ! I'll check the fuses doh to make sure their ok. What blower to be exact? Yea the water outlet only had four screws which I change because it had blown anti-freeze all over it! I'm pretty sure I did correctly but I'll double check just in case.

Was this

answer

helpful?

Yes

No

Wednesday, November 14th, 2012 AT 4:11 PM

HMAC300

MECHANIC
48,601 POSTS

Ok check both hoses for being hot first with engine warm. If they are then it's an internal heater problem. Ther ei sonly one blower for the heater an dthat moves the air does it work? Ifyu arenot getting hot air with the hoses hot then it's an actucator problem with the heater box, either it's vacuum or not getting power or not working. Pic inclosed fo actuator for your car. There should be 2 and they are interchangeable. However if you are not gettin gpower to them you should have it scanned to see if there is anything wrong with the controlpanel.

Image (Click to make bigger)