refer to our home page under the DIY section for directions and belt diagrams.

Answered by Jacobandnickolas (expert)
57,318 answers provided

A/C DRIVE BELT

1. Remove the engine under cover and splash shield (RH).

2. Cut the A/C drive belt using scissors.

3. Install a jig (A) to the crankshaft pulley as shown in the figure.
NOTE: The jig is prepackaged with a new A/C drive belt.

4. Install a new A/C drive belt to the A/C compressor pulley, move jig (A) upward, and then install the A/C drive belt to the crankshaft pulley.

5. Install jig (B) to the A/C compressor mount as shown in the figure.

CAUTION: The A/C drive belt cannot be reused.

NOTE: The jig is prepackaged with a new A/C drive belt.
Do not pass jig (B) through the A/C compressor mount hole.

6. Rotate the crankshaft pulley to the right using a wrench and install the A/C drive belt.

7. Install the under cover and splash shield (RH).

Answered by KHLow2008 (expert)
39,900 answers provided