2006 Mitsubishi Magna Repair Question
Topics covered: Clutch, Dust boot, Pressure plate.
Mileage: No information provided.
Mileage: No information provided.
Asked on August 13, 2011
Gear box
I want to replace clutch kit, but the gear box can't pull out.
I check the new kit,found the bearing will lock on the pressure plate when box fit in.
now I am stuck,the fork is stuck there too,
someone could help me? urgent.
I check the new kit,found the bearing will lock on the pressure plate when box fit in.
now I am stuck,the fork is stuck there too,
someone could help me? urgent.
Asked by changteAnswer
Replied on August 13, 2011
This will by a "pull type clutch" I presume that you are in Aust? as Magna is not on the US market, looking at the US data base for Mitsubishi, i can see pull type clutches that are used, with these you remove the slave cylinder, and remove the dust boot over the clutch lever, looking in side you should see a clip that locks the fork onto the pivot, pull this clip and the fork will remove out of the thrust and the box will then be free to remove.
