MAZDA B2300 CLUTCH PROBLEM
2006 Mazda b2300 • 109,000 miles
Problems shifting the manual transmission have been getting progressively worse. Replaced the clutch and pressure plate 15months ago. Problems continued. Replaced the Master Cylinder 3 months ago. Problems continued. The shop bled the whole system 1 week ago. Problems continued. Shop (claims they) just replaced the master cylinder again (it was under warranty) as well as the slave cylinder. Problems continue. Shifting always seems to be smooth as butter the day I get it back from the shop and then slowly I start having problems getting it in gear as I continue to drive it (by the end of the day). Pumping the clutch seems to help, which makes me believe that the problem is air bubbles in the hydraulic system like the shop says but I'm at a loss. They've bled the system 3 times now and it's not helping.
March 26, 2013.
March 26, 2013.
96 ford ranger 2.3l 2wd---hard to get into gear and grinds someitmes going into reverse. replaced- master cylinder, slave cylinder, throwout bearing, pressure plate, clutch disk, ...
3 answers • 1996 Ford Ranger • 192,000 miles
1998 Ford Mustang : I recently took my Mustang GT into a Ford service center for a slipping clutch. They told me that I have a self-adjusting clutch and that the clutch assembly needed ...
1 answer • 1998 Ford Mustang
1995 Nissan Maxima SE. Clutch began slipping about a week ago, then 'broke' loose and went to the floor as I was downshifting from 5th to 4th. Kabam! all the way to the floor and no ...
3 answers • 1995 Nissan Maxima • 270,000 miles
My car has been revving up even while in 5th gear and running on unusually high rpm's when any gas is applied, and it has had a burning brake smell if I drove it very far. Recently,the ...
2 answers • 2003 Mitsubishi Lancer • 130,000 miles