SPONSORED LINKS

Having difficulty removing starter. Limited space isnt allowing tools to be used / torqued

Tiny
ENVY0621I
  • MEMBER
  • 2007 JEEP COMMANDER
  • 100,000 MILES
Tried replacing our starter today, removed the plastic piece protecting the bottom. After removing the 4 bolts I notice the starter had very limited space to work from. We tried fitting our torque / lug in and un-torque-ing it but we are limited by space leaving us with no chance to remove it. Is there anything I can remove to make our job a little easier, as our 2nd car isnt operating and our wife is home with our new born without a working vehicle. Please help us, we are in dire need of any type of assisant.

thank you guys! In advance.
jimmy-
SPONSORED LINKS
Wednesday, April 18th, 2012 AT 1:08 AM

3 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Disconnect and isolate negative battery cable.
Raise and support vehicle.
Note: If equipped with 4WD, remove front drive shaft.
Note: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
Remove two bolts (3) if equipped with an automatic transmission.
Move starter motor (4) towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor during this process, do not let starter motor hang from wire harness.
Tilt nose downwards and lower starter motor far enough to access and remove nut (2) that secures battery positive cable wire harness connector eyelet (1) to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
Remove battery positive cable wire harness connector eyelet (5) from solenoid battery terminal stud.
Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle.
Remove starter motor.

This is the actual procedure.

Roy

There is a picture attached below to help show you where everything is located
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Wednesday, April 18th, 2012 AT 1:19 AM
Tiny
DANAGK
  • MEMBER
  • 1 POST
  • 2006 JEEP COMMANDER
  • V8
  • 4WD
  • AUTOMATIC
We been told that to get to the starter we will have to remover the front drive shaft. How do remove drive shaft on jeep commander 4wd 06.I read that will need to support something when the skid plate is off. Want to make sure cuz never worked on 4wd
Was this
answer
helpful?
Yes
No
Saturday, October 20th, 2018 AT 4:26 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,133 POSTS
The skid plate is mounted to the frame and doesn't support anything. Remove the skid plate (most likely the bolts will break) then simply unbolt the u bolts at the front drive shaft and unbolt the other end at the transfer case.
Was this
answer
helpful?
Yes
No
Saturday, October 20th, 2018 AT 4:26 PM (Merged)

Please login or register to post a reply.

Related Starter Replace/Remove Content

Starter Replacement
VIDEO
Starter Replacement
Instructional repair video
Starter Motor Replacement
GUIDE
Starter Motor Replacement
A starter motor is a high torque motor that utilizes a small pinion gear to contact the flywheel and a starter solenoid to initiate the electrical connection when the...

Sponsored links