2006 Chrysler 300 Repair Question
Topics covered: Engine, Rpm, Fuel injector.
Mileage: 89,000 miles.
Mileage: 89,000 miles.
Asked on November 17, 2012
Chrysler 300 Engine Problem
I JUST INSTALLED A RE-MANUFACTURED ENGINE in my 2006 Chrysler 300 base 2.7L.
everything went well, but it is still running rough.
It is putting out 2 codes 1. PO201-"injector circuit malfunction cylinder #1" and PO303- "cylinder #3 misfire detected". so far, I have replaced the fuel injector and the coil on number 1.Also, When I have the engine running at idle and pull connection wire to the coil, the rpm's drop, like they should. when I put the connection back on, rpm's increase, like it
should
everything went well, but it is still running rough.
It is putting out 2 codes 1. PO201-"injector circuit malfunction cylinder #1" and PO303- "cylinder #3 misfire detected". so far, I have replaced the fuel injector and the coil on number 1.Also, When I have the engine running at idle and pull connection wire to the coil, the rpm's drop, like they should. when I put the connection back on, rpm's increase, like it
should
Asked by (pending member)Answer
Replied on November 17, 2012
still running rough??? please explain
look for vacuum leaks for the missfire.
what did you do for the injector issue???
Roy
