P0741

Tiny
CUBASI2011
  • MEMBER
  • 2006 TOYOTA COROLLA
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 84,000 MILES
How do I fix a code P0741?
Friday, March 18th, 2011 AT 1:53 AM

6 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Hello,

This is the torque converter clutch control solenoid (SL) need to be replaced. Here are diagrams to help you get the job done below. Please let us know what happens. Cheers
Was this
answer
helpful?
Yes
No
+10
Friday, March 18th, 2011 AT 2:03 AM
Tiny
OIDAVEY
  • MEMBER
  • 0 POST
Thank you for this post I got new solenoid for $86.00 and the car is working great so far. I will let you know if it doesn't fix it.
Was this
answer
helpful?
Yes
No
+1
Tuesday, October 30th, 2018 AT 2:13 PM
Tiny
JANKI
  • MEMBER
  • 1 POST
  • 2005 TOYOTA COROLLA
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 55,000 MILES
I have a 2005 Automatic Toyota Corolla. In late December 2009, the check engine light came on with error code PO741. I took it to the Toyota dealership and they replaced the Engine Control Module and sent me on my way.

Less than one month later, January 2010, the check engine came on again with the same error code. I took it back to the same Toyota dealership, where the tech insisted the transmission had the wrong transmission fluid (Dextron fluid instead of Type T4). This is complete bullcrap because the car had no prior transmission work/maintenance done. At less than 50K miles, there was no need. But I wanted the car fixed so per the tech’s recommendation, I paid for a transmission fluid flush but the code PO741 is still on! The tech didn’t know what was causing the code and said I needed to authorize a complete tear down †with all costs out of my pocket because the car was now out of warranty - or simply replace the transmission entirely ($5K). As a student, I couldn’t afford either option.

Now, many months later, the PO741 code/check engine light cycles on and off every few hundred miles (250-350 miles).

I took it to an independent transmission specialist who test drove my car. He couldn’t be certain about the cause of the code, but thought it could be a bad clutch. He said I'd notice worst gas mileage (though not terrible) and that I needed to get it repaired ASAP in order to pass a smog check test. However, the repair would still cost thousands, which I simply cannot pay right now.

My questions are:

(1) What else could be the cause of the code? ECM has been replaced, transmission fluid has been flushed and replaced with correct T4 fluid. The car appears to drive fine. There's been no stalling or anything like that.

(2) What can I do to fix the code?

(3) If I were to take my car for a smog check during the time that the check engine light is not illuminated, will my car still pass the smog check? Can the tester see that the check engine light has been on and off X amount of times (the history) and fail my car for that reason?
Was this
answer
helpful?
Yes
No
+6
Tuesday, October 30th, 2018 AT 2:14 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,133 POSTS
What the code is indicating is there is no communication between the Torque Converter Clutch (TCC) and the ECM. Either there is a wiring issue to the component or the TCC is bad an needs replaced.

There are two things that the must occur for the TCC to work:

†Internal transmission fluid pressure must be correct.
†The ECM must complete a ground circuit to energize the TCC solenoid that moves a check ball in the fluid line. This allows the converter clutch to apply, when hydraulic pressure is correct.

If I had to guess (based on the vehicle's mileage, you have a bad connection or a bad ground at the ECM. Have the trans tech check for those problems first. As far as a trans overhaul, it won't correct the problem. THe transmission is fine. Also, you will notice a loss of MPG because when the TCC locks up, usually around 50MPH, it lowers the engine RPM's.

As far as the emissions testing, it will show up when they run a scan of the computer indicating the code was present. They will most likely ask that you drive the vehicle an additionl number of miles.

Let me know if you have other questions.
Joe
Was this
answer
helpful?
Yes
No
+10
Tuesday, October 30th, 2018 AT 2:14 PM (Merged)
Tiny
2CP-ARCHIVES
  • MEMBER
  • 4,542 POSTS
  • 2004 TOYOTA COROLLA
  • 13,000 MILES
2004 toyota automatic we have a code po741 seems to shift ok but itn says the tcc is stuck on changed all fluid and someone told me the tourqe conveter is stuck in lock up is this a computer problem or trans problem this is not the orig trans it has been replaced before let me know what you think
Was this
answer
helpful?
Yes
No
+1
Tuesday, October 30th, 2018 AT 2:14 PM (Merged)
Tiny
IMPALASS
  • MECHANIC
  • 3,112 POSTS
The attached information shows several things that could be the problem. I hate to say but I would try clearing the code and see if it returns. If it does, then you will have to take to a transmission shop for them to troubleshoot.
Was this
answer
helpful?
Yes
No
Tuesday, October 30th, 2018 AT 2:14 PM (Merged)

Please login or register to post a reply.

Sponsored links