2005 Dodge Caravan • 6 cylinder FWD Automatic • 107,000 miles
I have a 2005 dodge caravan and when I press on the breaks the wheel shakes and then I can hear a clinking noise and I checked the pades they are good the cv boot is good and the doesnt move if I try to shake it by hand. This is the passenger front side thanks for your time
April 13, 2011.
April 13, 2011.
That indicates brake rotor distortion. I would recommend replacing both the brake rotors and the pads to resolve the issue.
Now the rotors look good and when I start slowing down the stearing wheel shakes vigeressly usaly at 30 mph and about so that would be still most likely the problem is the rotors?
Then yes, my answer stands. Replace the pads and rotors and make sure the caliper slides are free in the process.
I have a winning noise that is coming from the engine. The noise comes from the engine, when you start the car the noise is there. And when the car gets warmed up the noise is not as ...
3 answers • 2002 Buick Rendezvous • 165,000 miles
Lately when i start my car, sometimes it'll make a static squeak like noise, also when shifting in neutral the static noise stops but the squeaky noise continues and gets a little ...
1 answer • 2000 Dodge Neon • 223,000 miles
Makes clanking noise while on fwd and reverse... drive shaft was removed to decrease sound. Just bought this truck under the promise that only bearings needed to be replaced.. Upon ...
3 answers • 1999 Chevrolet Silverado • 148,000 miles
Dear sir. I have a mark II , GX110. I have the following issue with the car. There is a pink noise like a dry bearing noise coming from the timing belt cover. Diagnostic. When I ...
7 answers • 2001 Toyota MR2 • 130,000 miles