How to locate the blower motor and resistor?

MORTYOSLO

MEMBER
2004 SUZUKI XL7
2.7L
V6
4WD
AUTOMATIC
60,000 MILES

Hi. Can anybody please tell me where to locate the blower resistor/fan control module. I think it's defective. If somebody can give me an hint it would be great. It's about -2 C outside and snow. It's he automatic temp. Regulator on it, the big knob on the left, the AC light can be turned on/of, checked the fuses under dash, and in engine room. If anybody have an electrical diagrams and/or where located I would be very happy.

Thank you in advance.
regards from
Morten J

5 Replies

HMAC300

MECHANIC
48,601 POSTS

This may be the controller for that, however there is a thing called a fan driver behind right headlight and the blower motor relay is behind right kick panel also check front blower fuse and meter fuse under dash fuse box.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

-1

Saturday, December 14th, 2013 AT 7:18 AM

MORTYOSLO

MEMBER
2 POSTS

Rigth kick panel. Is that the one on the passenger side on rigth side in front of the right door?

I'll look behind the right headlight tomorrow at dayligth.

. Is it an single relay, or is it close to the fusebox that is on the right side?

The fan regulator is the big knob in the middle. How is it possible/esasyest way to access behind there?

Thank you in advance.
Morten J

Was this

answer

helpful?

Yes

No

Saturday, December 14th, 2013 AT 11:12 AM

HMAC300

MECHANIC
48,601 POSTS

We dont' have real good things form Suzuki on these but it's infront of passenger door
Disconnect negative (-) cable at battery.
Disable air bag system.
For H25 engine model, refer to AIR BAG RESTRAINT SYSTEMS.
For H27 engine model, refer to AIR BAG RESTRAINT SYSTEMS.
Remove center lower box (1).
Fig. 23: Removing Center Lower Box
Courtesy of SUZUKI OF AMERICA CORP.
Remove center garnish mounting screw (1) and then pull off center garnish.
Remove harness and controller cover (2).
Fig. 24: Removing Harness & Controller Cover
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect BCM connectors and HVAC control module connector from each controller.
Remove center garnish (1) with BCM (2) and HVAC control module (3).
Fig. 25: Removing Center Garnish
Courtesy of SUZUKI OF AMERICA CORP.
Remove body control module (1), and then HVAC control module (2) as shown

Images (Click to make bigger)

Was this

answer

helpful?

Yes

No

Saturday, December 14th, 2013 AT 1:09 PM

GEMSTONE1US

MEMBER
1 POST
2004 SUZUKI XL7
150,000 MILES

Where would we find the blower motor and the blower resistor/fan control module?

Was this

answer

helpful?

Yes

No

Monday, January 11th, 2021 AT 4:08 PM (Merged)

RASMATAZ

MECHANIC
75,992 POSTS

This guide can help you fix it with the location of the blower motor and resistor in the diagrams below.

https://www.2carpros.com/articles/blower-fan-motor-works-on-high-speed-only

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Images (Click to make bigger)