2004 Chevrolet Impala AC compressor wiring harness

DARNDT

MEMBER
2004 CHEVROLET IMPALA
3.4L
6 CYL
2WD
AUTOMATIC
200,000 MILES

Wires broke off of the harness from the AC compressor. Need to know where to look for other end! :) Would like to be able to splice and or replace wires. Thanks!

Tuesday, September 2nd, 2014 AT 9:37 AM

3 Replies

HMAC300

MECHANIC
48,601 POSTS

The harness should be right by the compressor it may lead down to oil filter or in that area if it 's in back if not it should be near waterpump area. See pic for location and color. If you splice it make sure to solder connection an dto use shrink tubing to protect it after fixing.

Image (Click to make bigger)

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

-1

Tuesday, September 2nd, 2014 AT 10:00 AM

DARNDT

MEMBER
2 POSTS

Really need to know where that black and wire go to. They are hanging from the AC compressor. No clue where to reattach them, or where they go to. :(

Was this

answer

helpful?

Yes

No

Tuesday, September 2nd, 2014 AT 11:29 AM

HMAC300

MECHANIC
48,601 POSTS

I thought you had the end that goes to compressor. You need to connect to the compressor clutch which will require a connector. If auto parts doesn't have it go to a junkyard and get the connector then wire it in. On the connector in pic it will marked a and b wires correspond to that in other pic I sent. If this piece in pic is missing then you need a new compressor clutch.

Image (Click to make bigger)