SPONSORED LINKS

Transmission shift solenoids

Tiny
JOSE ARAIZA
  • MEMBER
  • 2006 CADILLAC CTS
  • 3.6L
  • V6
  • RWD
  • AUTOMATIC
  • 100,000 MILES
When I drive always when accelerating in between second and third gear my car jerks hard. Next weekend I when to a place to check my transmission and they said it had metal shavings and need it to rebuild the transmission but ""I think it is just the shifter solenoid that is getting clogged up or something" what should I do? Where is the shifter solenoid located? Should I replaced my self?
SPONSORED LINKS
Saturday, September 2nd, 2017 AT 6:09 PM

7 Replies

Tiny
STEVE W.
  • MECHANIC
  • 12,950 POSTS
Metal inside the transmission is not a good thing. Shift solenoids don't get clogged unless there is some debris (like metal shavings) floating in the fluid.
The shift solenoids are all inside the transmission. BUT from your description try this test first, Shift into low gear manually. Now shift up one gear at a time. Does the trans still jerk hard when going into 3rd gear? If it does it likely has internal damage and not an electrical issue.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, September 5th, 2017 AT 5:31 AM
Tiny
KELI JACKSON
  • MEMBER
  • 1 POST
  • 2004 CADILLAC CTS
  • 3.6L
  • V6
  • 2WD
  • AUTOMATIC
  • 167,000 MILES
I am not sure which solenoid in my transmission that needs to be replaced. When starting to drive and shift into drive it takes about 45 seconds before it engages into drive gear. I also have no fifth gear, cannot take it over 55 mph. Any ideas?
Was this
answer
helpful?
Yes
No
+1
Wednesday, March 31st, 2021 AT 9:42 AM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Is the check engine light on? If it is a solenoid, it will code.

https://www.2carpros.com/articles/automatic-transmission-problems

When was the last time you change the fluid and filter?

https://www.2carpros.com/articles/how-to-service-an-automatic-transmission

I attached the procedure for the pressure regulating solenoid. This could be your issue. The procedure with pictures are below.
Images (Click to make bigger)
Thumb
Thumb
Thumb
Was this
answer
helpful?
Yes
No
Wednesday, March 31st, 2021 AT 9:42 AM (Merged)
Tiny
KANGIE07
  • MEMBER
  • 1 POST
  • 2004 CADILLAC CTS
  • 3.6L
  • 6 CYL
  • AUTOMATIC
  • 242,000 MILES
Can you please tell me how to replace a solenoid?
Was this
answer
helpful?
Yes
No
Wednesday, March 31st, 2021 AT 9:42 AM (Merged)
Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 42,840 POSTS
You will need to drop the pan and the solenoids are in the valve body. You will need to raise the car safely here is a guide for that.

https://www.2carpros.com/articles/jack-up-and-lift-your-car-safely

This help help pull the pan and service the transmission

https://www.2carpros.com/articles/how-to-service-an-automatic-transmission

Here are some diagrams below showing you how to do the job.

Please let us know what happens.

Cheers, Ken
Images (Click to make bigger)
Thumb
Thumb
Thumb
Thumb
Thumb
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+5
Wednesday, March 31st, 2021 AT 9:42 AM (Merged)
Tiny
ALLISON509
  • MEMBER
  • 1 POST
  • 2003 CADILLAC CTS
  • 3.2L
  • V6
  • 2WD
  • AUTOMATIC
  • 130,000 MILES
I have these codes on my car:
DTC P0762 4-5 Shift Solenoid (SS) Valve Performance - No Fifth Gear
DTC P0700 Transmission Control Module (TCM) Requested MIL Illumination
DTC C1244 Powertrain Indicated Engine Drag Control Malfunction
DTC P0171 or P0174 Fuel Trim System Lean

I need to know if I can do the solenoid myself. Someone else is telling me I have to drop the transmission and send it out to California to get worked on and then have it shipped back out here.
I also have no idea what Powertrain Indicated Engine Drag Control Malfunction means. I have looked online and am not sure what is causing this or what it means.
Any help would be very much appreciated. Thank you.
Was this
answer
helpful?
Yes
No
Wednesday, March 31st, 2021 AT 9:43 AM (Merged)
Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 42,840 POSTS
Trouble codes are given in the order of importance so if you fix the solenoid the rest will probably go away. You can do the work yourself by removing the transmission pan this guide should help.

https://www.2carpros.com/articles/how-to-service-an-automatic-transmission

Here are diagrams to show you how to replace the 4-5 shift solenoid - below

Check out the diagrams (below). Please let us know what you find. We are interested to see what it is.

Cheers, Ken
Images (Click to make bigger)
Thumb
Thumb
Thumb
Thumb
Was this
answer
helpful?
Yes
No
+2
Wednesday, March 31st, 2021 AT 9:43 AM (Merged)

Please login or register to post a reply.

Related Transmission Shift Solenoid Location Content

VIEW MORE

Sponsored links