scan tool wont communicate with 2003 saturn l300

2003 SATURN L300
Avatar
DIDDO
  • MEMBER
  • 1 POST
stock alarm disconnected fuel system unresponsive
Apr 5, 2012 at 8:25 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Scantool might not be compatible-also check fuse Controls B+ 10amp in the underhood fuse block left side of engine compartment
Apr 5, 2012 at 9:50 PM
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
Just to add to this one i have seen a lot of the not being able to talk to the ecms being a bad bcm i have replaced a lot of them on that car.I would make sure the scan tool is compatible and works correctly.Also does the scan tool power up off the car?Also check to make sure the ecm has a nice tight clean ground to the intake manifold.
Apr 6, 2012 at 1:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.