2003 Saturn L200

WHIPPER69

MEMBER
2003 SATURN L200
4 CYL
FWD
AUTOMATIC
28,000 MILES

Changing centre brake panel lights on a 2003 Saturn L200

Friday, November 26th, 2010 AT 12:17 PM

4 Replies

KHLOW2008

MECHANIC
41,815 POSTS

Do you mean the high mount stop lamp?

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

+1

Friday, November 26th, 2010 AT 3:59 PM

WHIPPER69

MEMBER
3 POSTS

Yes. The centre stream mounted in the back window, of the six bulbs, I replaced 4 of them and one burnt out and only one remains lit when I brake. The four new ones dont light.

Was this

answer

helpful?

Yes

No

-1

Friday, November 26th, 2010 AT 5:15 PM

WHIPPER69

MEMBER
3 POSTS

Yes, the centre high stream of lights mounted in the back window. I needed to replace four of the six lights. One of the old lamps burnt out, only one remains lit. The four new replacements wont work.

Was this

answer

helpful?

Yes

No

Friday, November 26th, 2010 AT 5:19 PM

KHLOW2008

MECHANIC
41,815 POSTS

HIGH MOUNTED STOP LAMP REPLACEMENT
Removal Procedure

1. Remove the center high-mounted stop lamp cover by pulling down at the edges.

2. Remove the bulbs, if required.

3. Disconnect the electrical connector from the center high-mounted stop lamp.

4. Remove the center high-mounted stop lamp by pulling down to release the retainer tabs.

Installation Procedure

1. Position the center high-mounted stop lamp to the roof reinforcement.

2. Install the center high-mounted stop lamp by pressing into place until fully seated.

3. Connect the electrical connector to the high-mounted stop lamp.

4. Install new bulbs, if required.

5. Position the cover tabs to the slots.

6. Install the cover pressing into place until fully seated.

Images (Click to make bigger)