SPONSORED LINKS

Transmission/ Engine problem

Tiny
STEVIS
  • MEMBER
  • 2002 FORD E-SERIES VAN
  • V8
  • 2WD
  • AUTOMATIC
  • 83,000 MILES
2002 Ford cargo van E250. Two things. One the servise
engine light came on setting a code P1747 (EPC electronic pressure control. Pulled the pan and replaced the EPC and the SSA/SSB solenoids. The code is still being set and I dont know if it was befor but the off light blinks where you push the button for cutting out the over drive. Two the engine seems to have a problem it shakes or feels like somthing is breaking down under a load but is not setting any codes for engine problems? Are the problems related I dont think they are but not sure?
Steve
SPONSORED LINKS
Wednesday, March 2nd, 2011 AT 8:15 PM

8 Replies

Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Most likely wiring fault see diagnostic steps
Images (Click to make bigger)
Thumb
Thumb
Thumb
Thumb
Thumb
Thumb
Was this
answer
helpful?
Yes
No
Wednesday, March 2nd, 2011 AT 8:52 PM
Tiny
STEVIS
  • MEMBER
  • 28 POSTS
Is there any tepical problems with the lead frame?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, March 2nd, 2011 AT 9:18 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Don't understand question
Was this
answer
helpful?
Yes
No
Wednesday, March 2nd, 2011 AT 9:30 PM
Tiny
STEVIS
  • MEMBER
  • 28 POSTS
Sorry the lead frame is the conector shown in D5 of the diagnostic cahrt above. Also what about the engine performance problem in the Question?
Was this
answer
helpful?
Yes
No
Wednesday, March 2nd, 2011 AT 9:59 PM
Tiny
STEVIS
  • MEMBER
  • 28 POSTS
I replyed yesterday and referd to the chart above about the lead frame. It has been replaced also still sets P1747 right away and the off light blinks at the button for the O/D switch. All the wiring looks ok and conection are tight. Could it be a computer problem?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, March 3rd, 2011 AT 9:08 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Could be have you followed all steps in diagnostic flow charts?
Was this
answer
helpful?
Yes
No
Friday, March 4th, 2011 AT 3:46 PM
Tiny
STEVIS
  • MEMBER
  • 28 POSTS
Yes I went and took it to ford to double check everything and they also came back with the PCM needed replaced thank you for your advice.
Steve
Was this
answer
helpful?
Yes
No
Friday, March 4th, 2011 AT 9:41 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Hope that solves engine tick also
Was this
answer
helpful?
Yes
No
Friday, March 4th, 2011 AT 9:53 PM

Please login or register to post a reply.

Related Engine Shake Content

VIEW MORE

Sponsored links