Trying to remove Dash to get to heater core

2002 DODGE RAM
100,000 MILES
Avatar
WORKINGMANMEX
  • MEMBER
  • 2 POSTS
I have removed everything all dash screw and bracket screws on dash. It should roll down but the passenger side is loose but the drivers side seems to still be bolted down. Where exactly are the roll down bracket screws located. I have removed the larger bolts that mount the tube that goes through the dash from left to right side to the frome but dash still won't pull out. I subscribed to Mitchell1 online manual but it doesn't give very good picture illistrations.
Thanks
Dec 24, 2011 at 6:24 PM
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
Roll down bracket? Nothing rolls down about that dash. The entire dash has to be lifted off.
Make sure you got the ones above the steering column.
Dec 24, 2011 at 6:37 PM
Avatar
WORKINGMANMEX
  • MEMBER
  • 2 POSTS
Thanks I'll look for those are they different from the two nuts removed to drop the steering column.
I really apreciate the help
Dec 24, 2011 at 6:48 PM
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
Yes, they are.
Dec 24, 2011 at 6:51 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.