No starter operation - bad starter?

Tiny
MOM RUPPERT
  • MEMBER
  • 2002 CHRYSLER TOWN AND COUNTRY
  • 6 CYL
  • 141,000 MILES
I have a 2002 Chrysler town and country. The ignition has a clicking sound and won't starter very randomly. I have replaced the starter relay twice, but it still happens randomly. What is the selinoid
and could it be that? Or could it be an electrical problem? Please help.
Tuesday, August 2nd, 2011 AT 11:36 AM

4 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
You have to make sure the battery has a full charge and battery connections are clean and tight. With intermittent issues, You have to test when the problem is ongoing. Check the actual voltage readings at the starter, when problem is ongoing. Just make sure the tranny is in park or neutral and the e-brake is set, when testing. This guide can help us fix it

https://www.2carpros.com/articles/starter-not-working-repair

Please run down this guide and report back.
Was this
answer
helpful?
Yes
No
Sunday, November 26th, 2017 AT 8:46 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
The solenoid sits on top of starter. This is just generic explanation, the ignition switch sends voltage to solenoid, the solenoid then engages starter motor with battery. Low amp flow from ignition switch to solenoid. High amp flow from battery to starter. If replacement is necessary, replace as a unit.
Was this
answer
helpful?
Yes
No
Sunday, November 26th, 2017 AT 8:46 PM
Tiny
MOM RUPPERT
  • MEMBER
  • 2 POSTS
Whenever I bring it to my mechanic. Of course, it works for them. Starting right up. So it is hard for them to find the problem. I also have a left blinker that returns sometimes and not always. Could all this be related to an electrical problem of some sort. So frustrating. I am afraid to go anywhere.
Was this
answer
helpful?
Yes
No
Sunday, November 26th, 2017 AT 8:46 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
I understand, intermittent issues are a pain. You have to test when problem is ongoing. Do you have a digital multimeter? When the problem occurs check for good voltage and ground at the starter. If that checks out, I'd replace the starter and solenoid as a unit.
Was this
answer
helpful?
Yes
No
Sunday, November 26th, 2017 AT 8:46 PM

Please login or register to post a reply.

Sponsored links