2001 Volkswagen GTI Repair Question
I am looking to change the rear hub bearing.
Special tools, testers and auxiliary items required
Hub cap puller VW637/2
Fitting sleeve 3241
Assembly tool 3420
Torque wrench V.A.G. 1332
Torque wrench V.A.G. 1410
Loosen dust cap from seat by tapping lightly on the claw with hub cap puller VW637/2 .
Pull off dust cap.
Remove securing bolts - A - from brake caliper.
Remove brake caliper and hang up on body.
Remove Phillips-head screw for brake disc and take out brake disc.
Remove 12-point nut.
Pull off wheel bearing/wheel hub unit from stub axle.
A - Puller with leg clamp, e.g. Kukko 20/2
Pull off bearing inner race from stub axle.
Only use puller - A - with leg clamp e.g. Kukko 204-2 (commercial type).
Install wheel bearing/wheel hub unit as far as possible on stub axle.
Attach special tool 3420 and pull wheel bearing/wheel hub unit on to stop.
Caution: Make sure that the hubs/wheel bearing unit does not tilt!
Remove assembly tool 3420 ab.
Use a new 12-point nut - A - and tighten to 175 Nm (129 ft. lbs.) .
Install brake disc.
Drive in dust cap.
Always replace dust caps.
Damaged (dented) dust caps allow ingress of moisture, always use the tool illustrated. Always use tool illustrated to reduce chance of damage to dust cap.
Further installation in reverse order
Install and fasten wheel.
Fastener/location Tightening torque:
Brake caliper to rear axle
14,734 answers provided