How do I remove the old release bearing from the slave cylinder on a 2001 Mazda B3000?
May 4, 2011 at 7:01 PM
2001 Mazda B3000 release bearing replacement
2001 MAZDA B3000
PHILIP WARD
- MEMBER
- 3 POSTS
- FOLLOW
Advertisement
Release bearing is also called the throwout bearing located within the clutch assembly/tranny input shaft-You have to drop the tranny to get to it-
May 4, 2011 at 7:12 PM
Already out. How do I get the throwout bearing off of the slave cylinder?
May 4, 2011 at 7:33 PM
Twist release bearing and carrier assembly until preload spring pushes bearing assembly from slave cylinder. See Fig. 8 . Remove retainer ring.
NOTE:
Use only lithium base grease on release bearing. DO NOT use petroleum base lubricants.
NOTE:
Use only lithium base grease on release bearing. DO NOT use petroleum base lubricants.
Image (Click to enlarge)
May 4, 2011 at 7:53 PM
Never mind: I figured it out for myself; by using my eyes and my intellect....
May 4, 2011 at 7:53 PM
Have a nice day.
May 4, 2011 at 7:55 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.