Remove wheel , remove disc brake caliper and mounting bracket, remove axle shaft nut in the center of the hub. If equipped remove abs wheel speed sensor. Remove hub/bearing mounting bolts at the rear of the steering knuckle near the outer cv joint then remove the hub and bearing assembly from the steering knuckle. They tend to get stuck in the knuckle so you may need to use a hammer or a puller to remove it. Reverse the procedure to install. Torque specs wheel bearing / hub bolts 110-148 ft lbs.70 inch lbs for the abs sensor, 225 ft lbs for the axle nut

Answered by fixitmr
24 questions asked