CHRYSLER PT CRUISER SENSOR PROBLEM
2001 Chrysler PT Cruiser • 4 cylinder FWD • 133,000 miles
Did head gasket & cam belt now pt cruiser has no spark
No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs,coil's resistances,cap and rotor,distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it and keep testing
I have voltage of 12v to center of the 3 terminals to the coils when the key is 1st turned on then it drops quickly to 0v. On cranking the voltage is at 9.5v. when connected to the coils i have no spark at the plug leads
Cam sensor is new
Check the crankshaft position sensor-
Where is it on the engine & are the connectors easy to get at
This picture should help you locate it on the bottom of the engine near the oil filter.
July 21, 2011.
July 21, 2011.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as ...
3 answers • 2010 All Other Makes All Other Models
I have a 2000 bonneville ssei. It has 2 02 sensors. I get the code that says cat. sys. efficency ...
1 answer • 2000 Pontiac Bonneville • 150,000 miles
The service manual for my 1996 GMC Sierra tells me that my truck has four oxygen sensors. They are ...
1 answer • 1996 GMC Sierra • 125,000 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles