I replaced both o2 sensors and spark plugs car will not stay running or idle what do I do?
Thursday, October 4th, 2012 AT 11:08 AM
5 Replies
ASEMASTER6371
MECHANIC
52,797 POSTS
Should not have replaced anything till you know the failure.
Is the check engine light on?
Look for vacuum leaks. Idle air control may not be working. Throttle body may need to be cleaned.
Roy
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, October 4th, 2012 AT 11:10 AM
ALEXISGARVER
MEMBER
3 POSTS
Yes I scanned for codes before I did do anything and it only said oxygen sensor problems. Replaced those and spark plugs and didnt help. Could it be the coil pack?
Was this
answer
helpful?
Yes
No
Thursday, October 4th, 2012 AT 11:17 AM
ASEMASTER6371
MECHANIC
52,797 POSTS
What were the codes? O2 codes do not mean they need to be replaced, just that they cannot do there job.
No coil pack as it will not cause only an idle issue.
Did you check what I requested?
Roy
Was this
answer
helpful?
Yes
No
Thursday, October 4th, 2012 AT 11:23 AM
ALEXISGARVER
MEMBER
3 POSTS
It starting putting going up a huge mountain and then couldn't get it to go pass 30 mph when I pull off it just shut off on me. It starts just won't stay running it backfires when you start it also now it idles real ruff and then stalls out
Was this
answer
helpful?
Yes
No
Thursday, October 4th, 2012 AT 6:39 PM
ASEMASTER6371
MECHANIC
52,797 POSTS
I would check the fuel pressure to verify 40-45 lbs