car will not get fire

2000 CHRYSLER CONCORDE
108,000 MILES
Avatar
JENNIFERWILLIAMS
  • MEMBER
  • 2 POSTS
I have a 2000 chrysler concorde 3.2 i just swapped out the 2.7 for the 3.2 but im not getting any spark. it sounds like it is about to start but it wont fire. i tried to jump it too and it wont start. it does have gas.
May 7, 2012 at 1:38 AM
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
did you have to do any custom wiring?
May 7, 2012 at 1:52 AM
Avatar
JENNIFERWILLIAMS
  • MEMBER
  • 2 POSTS
no everything plugged right in
May 7, 2012 at 1:56 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
i would start with basics. check for fuel pressure, spark and compression. verify each one.

Roy
May 7, 2012 at 2:53 AM
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
did you hear new engine run before purchase? can you swap some ignition parts for old?
May 7, 2012 at 7:37 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.