2000 Chevrolet Blazer ignition problems

2000 CHEVROLET BLAZER
140,000 MILES
Avatar
DON WOHL
  • MEMBER
  • 1 POST
vehicle died while driving. after testing found no spark. replaced module in distributor, replaced crankshaft sensor ,cap and rotor, then found no voltage to coil. engine will run if i put jumper from battery plus to pink wire on coil. I'm trying to figure out where coil voltage originates.
Jun 1, 2013 at 6:13 PM
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
Have you checked all the fuses yet?
Jun 1, 2013 at 6:20 PM
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
Check to see if the ecm 1 fuse 15amp fuse as power to both sides of the fuse in the under hood fuse box with the key in the run position?
Jun 1, 2013 at 6:34 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.