2-PIN CONNECTOR BY THE POWER STEERING PUMP
1992 Ford F-150 • 120,000 miles
I have a 1992 Ford F-150 that I just finished replacing the head gaskets on. There is a 2-pin connector by the power steering pump that I cannot place. The end of it is clean as if it was plugged in previously, because the outside is covered in grease and oil. It comes off the huge mass of wires that goes to all of the injectors. It comes off about half-way from the computer to the engine. I will answer whatever questions I can so that I can get my truck back in precise condition again.
May 1, 2013.
May 1, 2013.
1994 Buick Roadmaster power steering pump locks up whenever water hits the serpentine belt when steering, Belt tensioner was replaced.
1 answer • 1994 Buick Roadmaster
Serpentine belt broke due to tensioner bearing freezing. Drove it for another 4 minutes and stopped before it reached max temperature/redline. It was stopped in a bad area, so waited ...
1 answer • 1998 Buick Regal • 45,000 miles
How to replace a power steering pump in my 1990 lexus es 250
1 answer • 1990 Lexus ES • 215,000 miles
1999 Ford Taurus mileage: 120,000. Is replacing the power steering hoses very difficult?
1 answer • 1999 Ford Taurus • 120,000 miles