Replacement of starter?
Dec 30, 2012 at 3:06 AM
1999 Toyota Camry Replacement Starter
1999 TOYOTA CAMRY
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Advertisement
REMOVAL
REMOVE BATTERY AND TRAY
w/ CRUISE CONTROL SYSTEM: REMOVE CRUISE CONTROL ACTUATOR
Disconnect the actuator connector and clamp.
Remove the 3 bolts, and disconnect the actuator with the bracket.
3. REMOVE STARTER
Disconnect the starter connector.
Remove the 2 bolts, throttle cable clamp (A/T) and starter.
Remove the nut, and disconnect the starter cable. Torque: 37 Nm (380 kgf.cm, 27 ft.lbf)
INSTALLATION
Installation is in the reverse order of removal.
since you provided no info on motor, i assumed it was a 4 cylinder.
roy
REMOVE BATTERY AND TRAY
w/ CRUISE CONTROL SYSTEM: REMOVE CRUISE CONTROL ACTUATOR
Disconnect the actuator connector and clamp.
Remove the 3 bolts, and disconnect the actuator with the bracket.
3. REMOVE STARTER
Disconnect the starter connector.
Remove the 2 bolts, throttle cable clamp (A/T) and starter.
Remove the nut, and disconnect the starter cable. Torque: 37 Nm (380 kgf.cm, 27 ft.lbf)
INSTALLATION
Installation is in the reverse order of removal.
since you provided no info on motor, i assumed it was a 4 cylinder.
roy
Dec 30, 2012 at 3:17 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.