Engine does not stay running

Try downloading the images and opening them locally. The wire colors are listed on them. I've looked for over an hour. That's what I was able to find.

Click on my name. Then click on Send a message. Send me your email address and I'll email them to you.

Sent. Good luck.

Mercedez timing-5 degrees BTDC
Heater core:
Disconnect battery negative cable and drain radiator. Disconnect blower motor wiring. From
under heater assembly, depress tab on mode door and temperature control cables, pull flags
from receivers and remove self-adjusting clip from door crank arms.
1.
Remove glove box assembly. Disconnect heater hoses on engine side of firewall. Plug hoses
and heater core tubes. Remove hanger strap to heater assembly screw by reaching through
glove box opening. Remove 2 heater assembly attaching nuts from engine compartment.
2.
On Daytona, remove 2 screws attaching demister adapter to the top of heater assembly. On all
models, pull instrument panel outward just enough to allow heater assembly to slide out.
Remove heater assembly. See Fig. 6. To install, reverse removal procedure.

Yes, according to my reference material, it's for the LeBaron front wheel drive.