Location of Crankshaft sensor

Hello,

Here is a guide that will walk you through the steps and a diagram below to show the location for your car.

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

On transaxle housing facing flywheel teeth

Crankshaft Position Sensor

ECCS Components Parts

ECCS Components Parts

The camshaft position sensor is a magnetic or hall effect sensor, this sensor reads information about the engine, camshafts and speed. It sends a signal to the computer relaying information about shaft speed, position and acceleration or deceleration. The function of the camshaft position sensor is important for the vehicle to run at its best, and maintaining a high level of performance and fuel economy. The information given to the ECU or the Electronic Control Unit dictates when the air fuel mixture is ignited and when to give more or less fuel in correspondence with the camshaft position, its speed and subsequently the valves position and speed. This is a very simple sensor to replace and service, and yet it serves a huge role in your vehicles performance and overall health.

The Crankshaft Position Sensor provides the reference signal to the PCM for spark and injector pulse and no, it won't effect mileage.

Misfiring is not the same as a set fault for the crankshaft sensor. Was the misfire fault there all along or is it showing up now that the crankshaft sensor has been replaced?

Inspect the ignition components for possible failures. Have the sparkplugs been recently replaced?