Car wont go into gear after been put in reverse

Tiny
ASH21488
  • MEMBER
  • 1999 FORD KA
  • 60,000 MILES
Hi, I have a ford ka 1999 V plate and when I put it in reverse it will make a big bang then then wont go into 1st gear but will 2nd and 3rd then when driven for a while will fix itself and go into gears normally can you tell me whats up and estimate price please?
Do you
have the same problem?
Yes
No
Sunday, August 12th, 2012 AT 9:15 PM

5 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Is this a stick shift?
Was this
answer
helpful?
Yes
No
Sunday, August 12th, 2012 AT 9:17 PM
Tiny
ASH21488
  • MEMBER
  • 3 POSTS
It's a manual gearbox think that's what you asking
Was this
answer
helpful?
Yes
No
Sunday, August 12th, 2012 AT 9:25 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
The problem should be with the clutch system and the cost would vary depending on what needs to be done.

Is the clutch pedal low? Did you check the clutch fluid level?
Was this
answer
helpful?
Yes
No
Sunday, August 12th, 2012 AT 9:32 PM
Tiny
ASH21488
  • MEMBER
  • 3 POSTS
How do I check clutch fluid level?
Was this
answer
helpful?
Yes
No
Sunday, August 12th, 2012 AT 9:36 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Underhood there is a small reservoir at firewall with markings for Max and Min. Remove the cap to check the level. It should be higher than MIN.
Was this
answer
helpful?
Yes
No
Sunday, August 12th, 2012 AT 9:53 PM

Please login or register to post a reply.

Sponsored links