CAR WANT STAY RUNNING
1998 Pontiac Bonneville • 242,752 miles
My car want run with out holding pedal down.its a 98 bonneville with no super charger. ive changed fuel pump.fuel pressure regulator.computer,coils,plugs wires,control module,mass airflow,idle air control valve...checked for vacuum leaks an there arent any,also changed pcv valve and egr an catalytic converter and o2 sensors im stuck
August 8, 2012.
August 8, 2012.
No there are no codes an coolant temp sensor has been replaced already
Yea it had good pressure no leaks. Computer ecm.coils.plugs.wires.iac valve.mass airflow.o2 sensors.catalytic converter.intake plenum.vacuum lines.cleaned the throttle.pcv am housing.tested the injectors.crank sensor.control module an harness.fuel pump an regulator
Yes didn't pull any codes or anything of concern just normal reading s
I know you replaced the coolant temp sensor but have you actaually compared the what the computer says for coolant temp with the actual coolant?To make sure its within 10 degrees all the way up till the radiator fan comes on?
Yes thermostat opens at right temp antifreeze is full and cmptr shows sensor properly reads
Just wondering what sensors i need to replace.codes as follows.p0135,p0155,p0133.two of the codes say bank 1 sensor 1 the other says bank2 sensor 1.I think bank means driver or ...
2 answers • 2002 Dodge Intrepid • 100,500 miles
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles