1998 Chrysler Sebring Repair Question
Asked on February 5, 2013
Chrysler Sebring Sensor Problem
Car has been going just great no problems starts just fine daughter drove it to store then gas station put 10 in now it want start at all no dead battery crank over but nothin any ideas or suggestions
Asked by twolfe59Answer
Replied on February 5, 2013
First check for diagnostic fault codes. The most common causes of a no-start after the engine has gone through a few minutes of "hot soak" is a failing camshaft position sensor or a crank shaft position sensor. They often become heat-sensitive and will work again after cooling down for about an hour.