SPONSORED LINKS

Clutch pedal on floor

Tiny
JAKEW13
  • MEMBER
  • 1997 NISSAN HARDBODY
  • 167,000 MILES
I replaced the slave and master cylinder and the clutch pedal is still to the floor and you have to pick it up with your hand and it wont engage. Clutch pedal on floor
Tuesday, November 8th, 2011 AT 7:19 PM

7 Replies

Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
The clutch master cylinder and the slave cylinder are sold two diff ways one to bleed this is a sealed unit and it comes with the two cylinders and line then you install and cut the holder on the slave but if these are okay this problem is common when the clutch needs to be replaced because it goes over center. Here is a video that shows a clutch repair ion a similar car the process is the same

https://youtu.be/JpzefqEeVGE

Please run down this guide and report back.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Tuesday, November 8th, 2011 AT 7:21 PM
Tiny
JAKEW13
  • MEMBER
  • 5 POSTS
Yeah I replaced them seprately and bled it still nothing. The clutch was engauging at the floor when I got the truck
Was this
answer
helpful?
Yes
No
+4
Tuesday, November 8th, 2011 AT 7:33 PM
Tiny
JAKEW13
  • MEMBER
  • 5 POSTS
The little fork the slave cylinder is up aginst is it suppose to be all the way on the lil rod cause it isnt far enough on it to push it
Was this
answer
helpful?
Yes
No
-1
Tuesday, November 8th, 2011 AT 7:36 PM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Yes when the slave is inverted as in clutch not pushed in the rod should be right against the arm then when the slave cyl extracts it should move the rod. If it is extracting and retracting as you operate the clutch. Then you have a problem with the throwout bearing or clutch. Inside the bell housing
Was this
answer
helpful?
Yes
No
+1
Tuesday, November 8th, 2011 AT 7:59 PM
Tiny
JAKEW13
  • MEMBER
  • 5 POSTS
So its the throw out bearing? The clutch pedal has no pressure an I have bled the heck out of it. About how much will this cost labor and all
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+2
Tuesday, November 8th, 2011 AT 8:27 PM
Tiny
JAKEW13
  • MEMBER
  • 5 POSTS
The fork is to far away from the slave for it to push it so I ordered a clutch kit and installed it watching the video you gave and all fixed! I love this site.
Was this
answer
helpful?
Yes
No
Tuesday, November 8th, 2011 AT 8:30 PM
Tiny
BILLYMAC
  • MECHANIC
  • 2,204 POSTS
Good to hear, please use 2CarPros anytime we are here to help.
Was this
answer
helpful?
Yes
No
Tuesday, November 8th, 2011 AT 8:55 PM

Please login or register to post a reply.

Related Transmission Clutch Pedal On Floor Content

VIEW MORE

Sponsored links