CAR STALLING ISSUE
1997 Nissan Altima • 2.4L 4 cylinder 2WD Automatic •
I have a Nissan Altima 97 SE edition. I just rebuilt the engine on it. I hooked everything up back where it spusse to go. The car starts then stalls almost immediatly. The funny crazy part is when I unplug the Throttle postion sensor and Mass air Flow sensor. The car starts up runs in limb mode or like a safe mode I was told. I have replaced the MAF and Throttle Postion sensor this time car starts then it seems likes outta gas or chokes itself. It runs a little bit loner then dies out any help I would appericate it Thanks
March 31, 2014.
March 31, 2014.
Check out the related content below while we wait for the question to be answered by a professional mechanic.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
2007 toyota camry 140k. Check engine light code Knock sensor. Reset and came back on right away. What could cause this other than the obviouse bad sensor or wire?
7 answers • 2007 Toyota Camry • 140 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles