CRANK PULLEY BOLT CAME LOOSE.
1997 Honda Accord • 99,000 miles
I had the crank pulley replaced. The man torqued it to 180 lbs. 3 months later it was wobbling and the two belts came off. Why do think it came loose?
June 27, 2012.
June 27, 2012.
Did he use any thread locking compound, always good insurance to use this as well.
Mark-Maybe the torque wrench is out of calibration
Uncle, even at that torque close would be ok, a bit of long term vibration and no locking compound would be my thought.
Totally agree Dundee-You have a great down under day-later bloke
Hi there my obd2 scanner says po741 on my 2005 toyota corolla with 124k miles. I have been reading so many conflicting answers about what the problem could be or the symptoms it should ...
5 answers • 2005 Toyota Corolla • 125,000 miles
1997 ranger 4r44e ...the torque converter is locked up... just before it locked up i could take off ramp on freeway and making a left turn to cross freeway it would slip like it went to...
1 answer • 1997 Ford Ranger • 148,000 miles
1998 Honda Acc. EX V6 1/2 qt. low on trans fluid added two days ago. When starting from red light or stop trans slips, sometimes. If I accelerate slowly all is ok. Today check engine ...
1 answer • 1998 Honda Accord • 1,110,000 miles
1996 Ford Explorer 2WD mileage: 85,000. I am going to change the transmission fluid for the second time in the vehicle. I had no problems the first time, however I only drained the ...
2 answers • 1996 Ford Explorer • 85,000 miles