1997 Ford Explorer Repair Question
Asked on January 27, 2012
Explorer XLT 1997vin E 4 L engine w/1998 r55 transmission flywheel need spacer to make connect torque coverter?
1998 explorer XLT vin e w/r55 automatic trans. changed engine (1997 vin e.
trans.torque converter won't connect (about 1/2")to flywheel without pulling torque too far forward. Does the 97engine need or should have a spacer between the flywheel and the crank end?
trans.torque converter won't connect (about 1/2")to flywheel without pulling torque too far forward. Does the 97engine need or should have a spacer between the flywheel and the crank end?
Asked by JamesyAnswer
Replied on January 27, 2012
You sure its stabbed in correctly and not hanging up on the pilot bearing
Replied on January 27, 2012
Hmmmm-Auto could be the input shaft is not sitting correctly in the TC-
Replied on January 28, 2012
Yes, it was installed properly, 2 times, to make sure.