start with a fuel pressure check.

Roy

Answered by ASEMaster6371 (expert)
24,845 answers provided

Fuel pressure is good, what else you got for me?

Response from bluerayzor
1 question asked

What's the readings? Are you getting spark and injector pulses?

Answered by rasmataz
68 questions asked

Update: no start issue was the starter. While working on the stalling, a stall test indicated a faulty torque converter. We have now replaced it but after the installation, neither the torque converter nor fly wheel move under manual force. Is this an early indication that the new converter is faulty?

Response from bluerayzor
1 question asked

stall test?? do you mean loading up in gear for max rpm??? how did you determine a bad converter??

if the motor does not turn after replacing, you most likely did not get the converter fully seated in the front pump locking up both the motor and trans.

Roy

Answered by ASEMaster6371 (expert)
24,845 answers provided

So what's your present situation? Be specific

Answered by rasmataz
68 questions asked

My chrysler kept shutting off going down road replaced crank sensor runs perfeact

Answered by codybyrd88
0 questions asked

what about the locking up and no start??? the crank sensor would not effect that

Roy

Answered by ASEMaster6371 (expert)
24,845 answers provided